Havit HV3288W-AB Stylez step Light Installation Guide
- June 5, 2024
- havit
Table of Contents
- Havit HV3288W-AB Stylez step Light
- Product Specifications
- Dimensions
- Mounting Base Diagram
- Important Safety Issues
- Steps for Installation
- Must be installed by a licensed electrician
- Warranty Terms & Conditions
- Additional Information
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Havit HV3288W-AB Stylez step Light
Product Specifications
Dimensions
Mounting Base Diagram
Important Safety Issues
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided
- When installing copper or brass fittings, gloves must be worn to avoid any oils transferring to the fitting.
- All 316 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on the fitting. (Warranty does not cover Tea Staining)
- All o-rings and seals must be in place correctly to maintain the warranty.
- These instructions may be updated at any time due to product improvements, Please visit the website for the most current installation instructions.
Steps for Installation
- Make sure that the electrical circuit is free of voltage (master switch off)
- Remove base plate from the fitting by loosening Allen screws on side of the fitting
- Install mounting bracket in the desired location.
- Using an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
- Connect the cable – If more than one fitting is installed, wiring must be done in parallel.
- Strip back the cable on both fitting and cable run and twist the positive cables together. Then connect neutral cables together
- Solder all joins using solder and either a heat gun or butane gas torch.
- Cover connections using an adhesive-lined heat shrink or gel cap to make the connection watertight. Failure to do this will void the warranty.
- Heat the heat shrink or crimp the gel cap making sure all connections are covered.
- Reattach fitting to base plate making sure Allen screws are tight to avoid water penetration
- Apply silicon around the edge of the fitting to prevent any water from getting inside to electrical connections.
- All Connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Must be installed by a licensed electrician
Contact Details
- 143 Beauchamp Road
- Matraville NSW 2036
- Australia
- Tel: 02 9381 8300
- Fax: 02 9666 8881
- Email: sales@havit.com.au
- Web: www.havit.com.au
Warranty Terms & Conditions
Additional Information
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>