PRONOMIC MIDI DX-165REC MKII DJ Mixer User Manual
- June 5, 2024
- PRONOMIC
Table of Contents
PRONOMIC MIDI DX-165REC MKII DJ Mixer
Important
safety instructions
- To protect against personal, third-party, or device damage read the following safety instructions and keep it at home for future reference.
- To avoid damage or electric shock this equipment must be protected from dripping or splashing water and submersion. If water has penetrated pull the mains plug immediately and remove any existing batteries.
- Do not place the device near heat sources such as heaters, stoves or other heat-radiating objects.
- Avoid mechanical shocks and check the unit regularly for damage on housing, power plugs and other accessories.
- Use only the accessories and attachments provided and approved by the manufacturer.
- A repair may only be carried out by qualified personnel. Unauthorized modification can affect safety and function.
- Listening at high volumes over a long period of time can lead to impaired hearing.
- The device or packaging may contain small parts that may be swallowed by children or cause suffocation.
- This device contains magnetic materials. If necessary ask your doctor about possible effects on implants such as pacemakers or defibrillators
PANELS
-
Front panel
- MIC INPUTS (1)
- Connect your microphones to these sockets
- MIC 1 LEVEL CONTROL (2)
- A correct setting of the controls for MIC 1 input GAIN is crucial for getting a good strong signal without noise or distortion
-
MIC 2 LEVEL CONTROL (3)
-
A correct setting of the controls for MIC 2 input GAIN is crucial for getting a good,strong signal without noise or distortion
-
MIC TREBLE TONE CONTROL (4)
-
This knob adjusts the treble of MIC 1 and MIC 2
-
MIC BASS TONE CONTROL (5)
-
This knob adjusts the bass of MIC 1 and MIC 2
-
CUE SELECTION for MIC 1 and MIC 2 (6)
-
Use the Cue Selection to monitor the selected MIC1-2 input source
-
TALK OVER SELECTION for MIC (7)
-
This switch has three positions. In OFF position, mic 1 and 2 are disabled. In
-
On position, mic 1 and 2 inputs are enabled. In talkover, the main signal is automatically reduced to listen the person who talk on mics connected in mic 1and 2 inputs
-
CHANNEL INPUT SELECTOR (8)
-
Each channel has a selector switch. This switch let you select which of the inputs plugged into the channel you wish to use: Mic, phono, Line or USB
player -
CHANNEL GAIN CONTROL (9)
-
A Correct setting of the controls for input GAIN for every channel is crucial for getting a good, strong signal without noise or distortion
-
TREBLE TONE CONTROL (10)
-
All stereo channels have a 3-band equalizer for tone shaping. The treble controls have fixed high frequencies and a boost/cut range of – 30dB/+10dB.
-
MID-TONE CONTROL (11)
-
All stereo channels have a 3-band equalizer for tone shaping. The mic controls have fixed middle frequencies and a boost/cut range of – 30dB/+10dB.
-
BASS TONE CONTROL (12)
-
Used to increase or lower the bass of the input channel.
-
CHANNEL CUE (13)
-
Use it to monitor the selected audio input source.
-
CHANNEL LEVEL CONTROL (14)
-
Let you control mixer’s overall channel volume level.
-
CHANNEL ASSIGN SELECTOR (15)
-
Let you select the input source to be mixed by the crossfader control.
-
CROSSFADER (16)
-
Allow you to cross-fade between the input sources assigned to channel A and channel B.
-
HEADPHONE CUE/PGM CONTROL (17)
-
Allows you to listen simultaneously or separately to the CUE material or th active program.
-
MP3 RECORD AND BLUETOOTH PLAYER (18)
-
a) USB/SD: Connect to USB stick and SD card.
-
b) LCD Display: The information is shown as playback support such as fil name, elapsed time, total time, file number, total file number, file system(MP3 or WAV) and playback mode (repeat one, repeat all, random orrepeat intro).
-
c) Six Buttons from left to right function as follows:
- Mode select: Short press to select the USB/SD and Blue tooth function. Long press to turn on/off the mode.
- Play/Pause: This button is used to start the playback or to enter in Paus mode.
- Folder/Record: A short press allows you to open the folder. A long press allows you to use the record function.
- Repeat/Delete: A short press to select the repeat mode (all, one and random). A long press to deal the recording file.
- |<< PREVIOUS: Use this button to re-start the track or to select theprevious track.
- >>| NEXT: Use this button to select the next track.
-
MASTER MONO/STEREO SELECTOR (19)
-
Select mono mode or stereo mode.
-
EQUALIZER ON/OFF (20)
-
Press it to turn equalizer on or off.
-
MASTER LEVEL CONTROL (21)
-
Let you control mixer’s overall master volume level.
-
BOOTH LEVEL CONTROL (22)
-
Let you control mixer’s overall booth volume level.
-
HEADPHONE LEVEL CONTROL (23)
-
Let you to control the volume level of headphone.
-
HEADPHONE JACK (24)
-
Works with headphones with 6,3mm plug.
-
EQUALIZER (25)
-
Allows you to tailor the mixer output to be cut or boost by up to 10dB.
-
DISPLAY METER (26)
-
Indicates the levels of left and right master channels.
-
POWER SWITCH (27)
-
Use this switch to turn on the unit after all input devices are already connected to prevent damage to you equipment. Turn the mixer on before you turn on amplifier and turn off amplifiers before you turn off the mixer
-
12V POWER SUPPLY JACK (28)
-
Allows you to connect 12v power supply via this jack.
-
Back panel
- GROUND CONNECTOR (29)
- The ground connector is a terminal for grounding turntables to eliminate hum.
- INPUT SELECTOR (30)
- Use the selector switch to switch from phono to line level.
- LINE INPUTS (31)
- Connect on these inputs either a Phono device or a line level device such as cdplayer or mp3-player
- EFFECTS INPUT/OUTPUT (32)
- Connect the send output jacks to the input of an effect or an echo chamber.
- Connect the return input to the output of an effect or an echo chamber.
- RECORD OUTPUT (33)
- Connect the mixer to a second receiver or amplifier powering speakers in theDJ booth or in a remote location.
- BOOTH OUTPUT (34)
- Connect the mixer to a second receiver or amplifier powering speakers in the DJ booth or in a remote location.
- AMP OUTPUT (35)
- Connect the mixer to a amplifier use cables.
- XLR BALANCE OUTPUT (36)
- Connect the mixer to a receiver use cables with XLR plugs.
- BLUETOOTH SOCKET (37)
- Connect to Bluetooth antenna.
- VOLTAGE SELECTOR (38)
- The select voltage which you need.
- POWER SUPPLY INPUT JACK (39)
- Input voltage from this jack
Specifications
Input Sensitivity/Impedance
- MIC 1-4—————————————————————— -1.5mV/600 Ohms, bal/unbal
- Phono 1-2—————————————————————————–3.0mV/ 50K Ohms
- Line 1-7——————————————————————————150.0mV/27K Ohms
Output Level
- Amp—————————————————————————————2.0V/10K Ohms
- Zone——————————————————————————— —–2.0V/10K Ohms
- Record———————————————————————————150Mv/10K Ohms
- Frequency Response———————————20Hz-20kHz +/-3 dB S/N Ratio ( at 1 kHz)
- MIC ———————————————————————————– 60 dB/ 1.5mV input
- Phono ———————————————————————————60 dB/ 3.0mV input
- Line ———————————————————————————–65 dB/ 150mV input
- Distortion
- MIC —————————————————————————————————– 0.5%
- Phono —————————————————————————————————0.5%
- Line ——————————————————————————————————0.5%
Equalizer
- Control Frequencies————————————————– 60, 250, 1K, 4K, and 12KHz
- Boost/Cut Range—————————————————————–+/- 10 dB from center
- MIC Tone Control
- Treble———————————————————————————–10kHz; +12/-12dB
- Bass———————————————————————————–100kHz; +12/-12dB
- Channel Tone Control
- Treble———————————————————————————–10kHz; +10/-30dB
- MID—————————————————————————————1kHz; +10/-30dB
- Bass———————————————————————————–100kHz; +10/-30dB
- Talk over Attenuation—————————————————————————— -16dB
- Echo Delay Time—————————————————————————50mS-120Ms
- Headphone output power——————————————————–125Mw @32 Ohms
- Power Source——————————————————115 VAC, 60Hz/ 230VAC, 50Hz
- Consumed power————————————————————————————–20W
- Bluetooth frequency…………………………………..…………………… 2402-2480 MHz
- Max.Transmission Power…………………………………………. …………..…… < 20mW
WEEE Declaration
Your product is designed and manufactured with materials and components of high quality, which are recyclable and can be reused. The symbol means that your product should be disposed of separately from household waste when it reaches its end of life. Please dispose of this equipment at your local collection point or recycling center. Please help to protect the environment in which we all live. All specifications and appearances are subject to change without notice. All information was correct at time of printing. Musikhaus Kirstein GmbH does not guarantee for the accuracy or completeness of any description, photograph or statement contained in this manual. Printed colors and specifications may vary slightly from product. Products from Musikhaus Kirstein GmbH are only sold through authorized dealer. Distributors and dealers are not agents of Musikhaus Kirstein GmbH and have no authority to bind Musikhaus Kirstein GmbH legally in any way. This manual is protected by copyright. Any copying or reprint, even in excerpts, is only allowed with written consent of Musikhaus Kirstein GmbH. The same applies to reproduction or copying of images, even in altered form. SIMPLIFIED EU DECLARATION OF CONFORMITY Hereby, Musikhaus Kirstein GmbH declares that the radio Equipment type [Pronomic DX-165REC MKII] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.kirstein.de/docs/Konformitaetserklaerung/CE_Konformitaetserklaerung_00059209.pdf
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>