sharperimage SF520 Digital Door Viewer User Manual
- June 5, 2024
- sharperimage
Table of Contents
SF520 Digital Door Viewer
User Manual
PRODUCT IMAGE AND PARTS
1. Battery bin | 4. Power Key |
---|---|
2. Testing interface | 5. Outdoor Camera |
3. LCD display |
Technical specification
Display screen | 3.5′ LCD color screen, Resolution of 480’320 |
---|---|
Image sensor | 2.0 mega pixel camera resolution |
Real viewing angle | 120°real viewing angle |
Supply power | 4pcs MA batteries |
Door hole diameter | 14-28mm |
Door thickness | 40-100mm |
Indoor device size | diameter:32mm |
Outdoor device size | 118x62mm |
Function operations:
Pressing the power button to display the image, through the display screen to observe the scene outdoor, after 15s, the unit will be off automatically.
- Power on: pressing the power button
- Power off: power off automatically after power on 15s; During power-on status, press power button 3s to make power off, too.
Installing Diagram and Instruction
Step 1: Take out the screws bag and choose the suitable screws according
to the door thickness, insert the screws to the outdoor camera bracket, and
lock the screws loosely using a screwdriver.
Step 2: Put the outdoor unit with screws into the door hole, Remove the
bracket from the indoor unit, Pass the outdoor unit cable through the up-hole
of the metal bracket, and the screws from the downhole, Please make sure the
outdoor unit and indoor bracket in the right direction (up arrow means
upward). Then, move the metal bracket to the left and make the screws lock it,
then, use a screwdriver to tighten the screws again to fix the metal bracket
and outdoor unit firmly.
Step 3: Open the battery slot to insert the batteries according to the
right instructed direction on the slot cover.
Step 4: Connect the cable from the outdoor unit to the connector of the
indoor unit in the right direction.
Step 5: The four slots on the back of the indoor unit is aligned with
four projection on the mental bracket and buckle up, then, pull down the unit
to lock tightly.
Step 6: Remove the protective film from the indoor unit and outdoor unit
surface.
Installation finished.
Installation Caution
-
Please make sure never to pull the camera cable in case it breaks it.
-
The indoor monitor is connected to the outdoor camera by a cable, please press the cable connector appropriately when connecting it to the monitor and remove it with thumb and index finger instead of pulling directly.
-
Please make sure the AAA battery pole is right when inserting it in case it damage the product chip.
Please don’t insert new and used batteries together. -
Please don’t press hard on the LCD screen; Please don’t shake and shock the unit. It is not allowed to use in high temperatures, high humidity, or dusty conditions.