HOLOSWIM2 Smart Goggles User Manual

HOLOSWIM2 Smart Goggles User Manual

PRECAUTIONS
The product and its accessories are intended for recreational use only and should not be used for medical or related purposes in any form.
Do not use the product in an ambient temperature below 0°C or above 35°C.
Do not expose the goggles to direct sunlight, place them in a car, or in contact with sharp objects to prevent damage.
Use a USB adapter that meets safety standards.
Do not use a charging cable not supplied with this product.
Keep the charging cable and charging port of the goggles (including the surrounding areas) dry during charging.
This product contains a built-in lithium battery. Do not throw it into or use it near an open flame. Clean the goggles with cold water after each use and dry them naturally. Do not touch the inside of the lens.
If you feel unexpected pain, excessive fatigue, or other discomfort when using this product, stop using it immediately.

* This product contains small components that may cause suffocation on ingestion. Children should only use the product with guidance of their guardians.

ACCESSORIES

*Contents may differ depending on package.

SPECIFICATIONS

CHARGING INSTRUCTIONS

Charging instructions: When the red LED indicator flashes, the battery voltage is low. Connect one end of the charging cable to the USB power supply and the other end to the goggles for charging (note that the magnetic charger must be tightly attached to the charging port of the goggles). The green LED indicator will flash during charging, and change to solid when the battery is fully charged.

OPERATION INSTRUCTIONS

Power button:
Press and hold this button to power the device on/off.
Press to pause/resume swimming.

Function button:
Press to enter the function menu or switch function options.
Press and hold to start swimming.

*Press both the power button and function button at the same time to enter the device information page. Press any key to exit from this page.

WEARING

1. Put the goggles on your eyes
2. Pull the strap over your head and buckle up to make your eyes comfortable.
   Adjust the length of the strap if necessary.

How to remove:

1. Remove the strap from your head
2. Remove the goggles from your eyes.
   

* Do not lift or remove the goggles without removing the strap, or the lens may rebound and hurt the eyes.

SIZE ADJUSTMENT

Adjust the strap tightness and/or replace the bridge to ensure comfort and sealing performance. This product provides four bridge options. In order to prevent the bridge from falling off, ensure that it is tightly attached to the mounting hole of the goggles.

‘Place the bridge into a storage box and carry it with you for easy replacement when you use the goggles for the first time.

DOWNLOADING AND INSTALLING THE APP

Scan the QR code below to download and install the app. Register your account on the app as instructed.

INSTRUCTIONS

1. Bind Device: Press and hold the Power button to power on the goggles.
   When the “waiting for connection” screen is displayed on the goggles, start the app and bind the device

2. Goggle Settings: After the goggles are bound to the app, set the swimming display and parameters 0 the app, then select Start Swimming on the goggles.

3. Start Swimming: On the goggles, press the function button to enter the menu page, then press the Function button again to select the corresponding swimming display mode.
   You can press and hold the function button to start swimming.
   ‘Swimming data will be displayed on the screen in real time during swimming.

4. Pause/Resume Swimming: You can pause/resume swimming by pressing the function or power button of the goggles during swimming.

5. End Swimming: Press and hold the function or power button to end or resume swimming.
   Swimming data will be automatically saved.

6. Upload Data: Connect the goggles to the app after swimming to automatically upload data to the app

* Note: Try to keep your goggles close to your smartphone when uploading data,

CE STATEMENT

There are no restrictions of use.
Hereby, Hangzhou Guangli Technology Co., Ltd. declares that this product is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address https://www.guangli.com/credentials/

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a residential installation, This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna,
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,
• Consult the dealer or an experienced radio/TV technician for help.

Devices shall bear the following statement in a conspicuous location on the device:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Caution: Any changes or modifications not expressly approved by Hangzhou Guangli Technology Co., Ltd. for compliance could void the user’s authority to operate this equipment.

Company Name:
Hangzhou Guangli Technology Co., Ltd.
Company Address:
698 Xixi Road, Huatai Pioneer Park Building#15 6F, Xihu District, Hangzhou, Zhejiang, China
Website:
wwww.guangl.com
Tel.:
+86 400-808-111

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>