SENCOR SWS TH5051-5451-5551 Wireless Hygro Thermo Outdoor Sensor User Manual

SWS THSO51-5451-5551
WIRELESS HYGRO-THERMO OUTDOOR SENSOR
User Manual

SWS TH5051-5451-5551 Wireless Hygro Thermo Outdoor Sensor

1. LED indicator – Flashes when the remote unit is transmitting.
2. LCD display to show the detected temperature or humidity of the sensor.
3. Wall mounting holder 6. Battery compartment
4. [ RESET ] key – Press to restart the sensor.
5. ( CHANNEL slide switch – Assign the transmitter to Channel from 1 to 3.
6. Battery compartment – Accommodates 2 x AA size batteries.

BEFORE USING THE OUTDOOR SENSOR

1. Remove the battery door.
2. Insert 2 x AA size batteries into the battery compartment. Make sure you insert them the right way according to the polarity information marked on the battery compartment.
3. Replace the battery door. The sensor will now start transmitting signals, and the LED indicator flashes.
   Note:
   – Once the channel is assigned to a sensor, you can only change it by removing the batteries or resetting the sensor, you also need to press the [SENSOR] key on the main unit to pair this sensor.
   – Avoid placing the transmitter in direct sunlight, rain or snow. – To avoid the wireless sensor and main unit pairing failure, please power up the sensor/s first, and then press [ RESET ] key on the main unit (no need on sensors).
   – The building material and the position of the receiver and transmitter affect the effective range. So try various locations to obtain the best result.
   – Place the units away from metal objects and electrical appliances to minimize interference. Position the receiver and transmitter within the effective transmission range: 30m in usual circumstances.

TEMPERATURE AND HUMIDITY DISPLAY
The LCD of the sensor will alternately display temperature and humidity in about every 4 seconds.

BATTERY REPLACEMENT

When the batteries in the sensor are low, the low battery icon will be displayed on its LCD. Please replace it with new batteries.

IMPORTANT NOTE

• Do not subject the unit to excessive force or shock.
• Do not expose the unit to extreme temperatures, direct sunlight, dust or a moist environment.
• Do not immerse in water.
• Avoid contact with any corrosive materials.
• Do not dispose of this unit in a fire as it may explode.
• Do not open the inner back case or tamper with any components of this unit.
• Please dispose of used units or batteries in an ecologically safe manner.

SPECIFICATION

INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING MATERIALS
Dispose of packaging material at a public waste disposal site.
DISPOSAL OF USED ELECTRICAL AND ELECTRONIC APPLIANCES
** The meaning of the symbol on the product, its accessory or packaging indicates that this product shall not be treated as household waste.
Please, dispose of this product at your applicable collection point for the recycling of electrical electronic equipment waste. Alternatively in some states of the European Union or other European states you may return your products to your local retailer when buying an equivalent new product. The correct disposal of this product will help save valuable natural resources and help in preventing the potential negative impact on the environment and human health, which could be caused as a result of improper liquidation of waste. Please ask your local authorities or the nearest waste collection centre for further details. The improper disposal of this type of waste may fall subject to national regulations for fines.
For business entities in the European Union
If you wish to dispose of an electrical or electronic device, re-quest the necessary information from your seller or supplier.
Disposal in other countries outside the European Union
If you wish to dispose of this product, request the necessary information about the correct disposal method from local gov-ernment departments or from your seller.
** The product meets EU requirements.
Hereby, FAST CR, a.s. declares that the radio equipment type SWS THSO51-5451-5551 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.sencoreu
Changes to the text, design and technical specifications may occur without prior notice and we reserve the right to make these changes.
The original version is in the Czech language.
Address of the manufacturer: FAST CR, as., Cernokostelecka 1621, Aieany CZ-251 01

Warranty conditions

 Warranty card is not a part of the device packaging. This product is warranted for the period of 24 months from the date of purchase to the end- user. Warranty is limited to the following conditions. Warranty is referred only to the customer goods using for common domestic use. The claim for service can be applied either at dealer’s shop where the product was bought, or at below mentioned authorized service shops. The end-user is obligated to set up a claim immediately when the defects appeared but only till the end of warranty period. The end user is obligated to cooperate to certify the claiming defects. Only completed and clean (according to hygienic standards) product will be accepted. In case of eligible warranty claim the warranty period will be prolonged by the period from the date of claim application till the date of taking over the product by end-user, or the date the end-user is obligated to take it over. To obtain the service under this warranty, end-user is obligated to certify his claim with duly completed following documents: receipt, certificate of warranty, certificate of installation.
This warranty is void especially if apply as follows:

• Defects which were put on sale.
• Wear-out or damage caused by common use.
• The product was damaged by unprofessional or wrong installation, used in contrary to the applicable instruction manual, used in contrary to legal enactment and common process of use or used for another purpose which has been designed for.
• The product was damaged by uncared-for or insufficient maintenance.
• The product was damaged by dirt, accident of force majeure (natural disaster, fire, and flood).
• Defects on functionality caused by low duality of signal, electromagnetic field interference etc.
• The product was mechanically damaged (e.g. broken button, fall). — Damage caused by use of unsuitable media, fillings, expendable supplies (batteries) or by unsuitable working conditions (e.g. high temperatures, high humidity, quakes). Repair, modification or other failure action to the product by unauthorized person. End-user did not prove enough his right to claim (time and place of purchase). Data on presented documents differs from data on products. Cases when the claiming product cannot be indentified according to the presented documents (e.g. the serial number or the warranty seal has been damaged). Authorized service centers Visit www.sencor.eu for detailed information about authorized service centers.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>