Electrolux E4WP31 902980184 Metal Cover Instruction Manual
- June 4, 2024
- Electrolux
Table of Contents
E4WP31 902980184 Metal Cover
Instruction Manual
Appliance overview
Your washing machine can be adapted to undercounter installation by using an
undercounter panel installation kit Model denomination E4WP31 Part Code
9029801843.
Verify your machine model compatibility through the internet site on the
Consumable & Accessories session, by inserting PNC or model denomination prior
to using the kit!
WARNING!
Conversion to undercounter installation must be handled by a professional
technician or service engineer only! 
Built-in dimensions
This appliance has been designed to be built into the kitchen furniture or
undercounter installation, with a visible front of the machine.
Before proceeding with appliance building in, bring it near the recess and
preset the inlet hose, the drain hose and the mains cable. Adjust the height
of the feet to the minimum in order to prepare the appliance to be inserted
into your furniture recess.
The recess should have the dimensions shown in this picture (il.2).
WARNING!
Make sure that hoses and main cable are not kinked or squashed.
Make sure not to have uneven flooring inside the furniture recess!
Installation Instructions
Tools needed: Electrical screwdriver with Cross, Torx T20 & Hexagonal 7, 8 mm bits
A
- To install the kit please remove the original worktop by unscrewing the two back top fastening screws located left and right side on the machine back.
- Use a screwdriver with a cross (or hexagonal 8mm) bit.
- Save the 2 screws removed as they will be reused afterward.
- Slide the Worktop towards the back to disengage it from the front fastening. Store the original worktop for any future reuse, if the case.
- Open the conversion kit package to access the flat steel metal panel.
B
- Please unscrew and remove the 2 front screws highlighted by the arrow.
C
-
Seal assembly between facia panel and front beam.
-
Remove the hexagonal head screws that hold the facia panel on LH & RH front side, using a 7 mm bit.
-
Unsnap the highlighted facia panel hook (il.4). Facia panel can go in ajar condition.
-
Take the grey-shaped rubber seal from a kit, and position it between the facia panel hook and RH machine side, with three shapes on the bottom (il.5).
-
Re-snap the facia panel hook, and re-use the 7 mm hexagonal head screws on LH & RH sides.
-
The seal will be kept in position between the facia panel and the top front beam (il.6).
D
- Take the metal worktop and assemble it on the machine by sliding it on the top of the machine.
- Pay attention to inserting the front middle protruding rivet and engaging it inside its own slot on the machine front beam!
- Ensure that the rubber facia panel rubber seal is going underneath the metal panel flanged profile!
- Push the metal top towards the machine front, such as to have the protruding back ears going in contact with the machine cabinet back.
- Reuse the 2 original screws which at point 1.3.A, to fix the metal worktop on the back (il.7).
E
- Take the hardware bag from the kit packaging and complete the top 4 fastenings using 4 screws M5x20. Please note that the top right middle screw shall be fixed at last one using an electrical screwdriver (Pos. 4 -Metric self-holing screw).
- Please complete the screwing by screwdriver with low speed selected.
This is to avoid over screwing. All 4 top fastening have Torx Bit T20 (il.8).
Your machine is ready to be built into your furniture.
WARNING!
Make sure that the main cable and hoses are not kinked or squashed! Ensure
final machine leveling by adjusting front feet 2!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>