besrey BR-C760 Gravity Fold Stroller Instruction Manual
- June 4, 2024
- besrey
Table of Contents
besrey BR-C760 Gravity Fold Stroller
WARNING
Please follow all of these instructions to ensure the safety of your child.
Failure to follow these instructions and/or warnings could result in serious
injury or death. Keep these instructions for future reference.
- To avoid serious injury from falling or sliding out, always use the safety harness and ensure that the child is properly positioned according to these instructions.
- Never leave a child unattended.
- Care must be taken when folding and unfolding the stroller to prevent finger entrapment.
CAUTION : This stroller is designed for one child only. Use with more than one child may cause an unbalanced condition which can injure/harm your child.
- This stroller’s maximum weight capacity is 50 lb (22.7 kg), and it is recommended for a child above 6 months old or no taller than 40 in (101cm). Additional weight will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition to exist.
- Purses, shopping bags, parcels, diaper bags, or accessory items may change the balance of the stroller and cause a hazardous, unstable condition.
- Before putting the child in or taking the child out of the stroller, as well as when it is stopped, ensure that the brake is securely locked.
- The maximum weight that can be carried in the storage basket is 4.4 lb (2kg). Excessive weight may cause a hazardous unstable condition to exist.
- The maximum weight that can be carried in the backside pocket is 1 lb (0.5kg). Excessive weight may cause a hazardous unstable condition to exist.
- The maximum weight that can be carried in the cup holder is 1 lb (0.5kg). Excessive weight may cause a hazardous unstable condition to exist.
- NEVER use the stroller on stairways or escalators.
- NEVER use the stroller with roller skates, in-line skates, skateboards, or bicycles.
- NEVER allow your stroller to be used as a toy.
- To clean use ONLY MILD household soap or detergent and warm water on a sponge or clean cloth.
- Check your stroller for loose screws, worn parts, torn material, or stitching regularly. Replace or repair parts as needed.
- Discontinue use of stroller should it malfunction or become damaged.
IMPORTANT! To ensure the safe operation of your product, please follow
these instructions carefully. Please keep these instructions for future
reference.
IMPORTANT! Before assembly and each use, inspect this product for damaged
hardware, loose joints, missing parts, or sharp edges. NEVER use if any parts
are missing or broken.
IMPORTANT! Adult assembly is required.
CD Canopy| @ Fold Latch
@ Fold Button| (/) Storage Basket
@Guardrail| ® Cup Holder
@ Safety Harness| ® Backside Pocket
@ Foot Support| ® Brake
PARTS LIST
The product includes the above parts, please check carefully before assembly, DO NOT use the product if any part is missing.
ASSEMBLING THE STROLLER
Step 1.
Unfold the stroller as depicted:
A) Lay the stroller down. Unlock the fold latch by pulling it outward.
B) Press the Fold Button on the top handle and rotate the top handle forward.
C) Pull upward on the stroller’s top handle to extend the frame.
D) Release the handle to let it lock into position. You’ll hear two “Clicks”
when securely extended.
WARNING: The stroller MUST be fully extended and locked into position
before use.
WARNING: DO NOT unfold the stroller with children nearby. Take care when
unfolding the stroller to prevent finger entrapment.
Step 2.
Lean the stroller backwards, and assemble the wheels as depicted:
A) Push each Front Wheel into the front wheel housing until you hear a
“Click”.
B) Push each Rear Wheel into the rear wheel housing until you hear a “Click”.
WARNING: Pull on the wheels to ensure that they are securely attached to the stroller.
Step 3.
Line up the Guardrail anchors with the slots above the seat. Slide the
Guardrail into place until you hear a “Click”.
WARNING:
- DO NOT put a child car seat inside the stroller.
- The Guardrail must be securely attached before use.
- DO NOT detach the Guardrail while the infant is inside.
- DO NOT use the Guardrail to carry the stroller with a child inside.
Step 4.
The product is ready for use.
WARNING: Check every part is tight before use.
USING THE STROLLER
Using The Safety Harness:
The Safety Harness comprises 5 straps that secure the child from different
angles.
To secure the child, you should:
A) Place the child in the stroller seat and bring the safety harness around the child’s waist and over the child’s shoulders.
B) Connect the Shoulder Strap with theWaist Strap to the buckle on the Crotch Strap, and then repeat on the opposing side to fully join all the straps together.
C) Use the adjustable buckle to ensure a snug fit.
To release the harness, push on the center clasp to let the buckles pop free.
WARNING: ALWAYS use the safety harness to avoid injury from falling or sliding
out.
STRANGULATION HAZARD: Child can become strangled in loose straps. NEVER leave
a child in the seat unattended when straps are loose or undone.
To adjust the harness height, you should:
A) Place the Shoulder Straps level with the top of the child’s shoulders.
B) If the height of the straps needs to change, remove the securing buckles from the seatback and re-secure them through another slot on the seatback.
C) Grip and pull the securing buckle through the slots and ensure they are flat against the seatback.
WARNING: ALWAYS ensure the securing buckles are fully through the seatback and sitting flat against the hard part of the seatback.
Seatback Adjustment:
A) To recline the seatback, press the clip on the strap behind the seatback, lower the clip down to the desired position, and then release the clip.
B) To lift the seatback, press the clip and raise it to the desired positi on, and then release the clip.
WARNING: The upright position should be used ONLY for a child that is at
least 6 months old.
WARNING: ALWAYS re-adjust the safety harness after adjusting the
seatback.
The Brakes:
A) To lock the wheels, press down the brake pedal on the rear wheel (right- side).
B) To release the brakes, lift the brake pedal.
WARNING:
ALWAYS apply brakes when the stroller is not being pushed. NEVER leave the
stroller unattended in any situation.
Check that the stroller cannot roll after engaging the brakes.
Using the Storage Basket:
The storage basket is accessed from the rear of the stroller underneath the
seat. Placing the seatback in the upright position may help better access the
storage basket.
WARNING:
The maximum bearing weight of the storage basket is 4.41b (2kg). NEVER put a
child in the storage basket.
Foot Support Adjustment:
A) Lift to raise the Foot Support until you hear a “Click”.
B) Pull the release handle underneathto lower the Foot Support.
The Canopy:
A) Push forward on the front edge of the canopy to open it; the canopy may be extended further by unzipping the zipper.
B) Pull backward on the front edge of the canopy to fold it up.
Using the Window:
Use the magnetic snap fasteners to open and close the view window at the top
of the canopy.
FOLDING THE STROLLER
Step 1.
Press the brake pedal to lock the wheels.
WARNING: DO NOT fold the stroller with a child nearby. Take care when unfolding the stroller to prevent finger entrapment.
Step 2.
Push in the Fold Button on the top handle and rotate the top handle forward.
Step3
Push forward and downward on the stroller. Then let go of the handle to allow
gravity to fold the stroller frame.
Step 4.
Ensure the Fold Latch is secured in position when the frame is fully folded.
May require lifting the sliding tab.
UNFOLDING THE STROLLER
Step 1.
Unlock the Fold Latch by pulling it outward.
Step 2.
Press in the Fold Button on the top handle and rotate the top handle forward.
Step 3.
Pull upward on the stroller’s top handle to extend the frame.
Step 4.
Release the handle to let it lock into position. You’ll hear two “Clicks” when
the stroller is fully extended.
WARNING: The stroller MUST be fully extended before use.
WARNING: DO NOT unfold the stroller with a child nearby. Take care when
unfolding the stroller to prevent finger entrapment.
MAINTENANCE
This product requires regular maintenance. The cleaning and maintenance of the crib MUST ONLY be carried out by an adult.
To Release Front Wheels:
Press the release latch and pull the front wheels out.
To Release Rear Wheels:
Press the release latch and pull the rear wheels out.
Guardrail Release:
Press buttons on both sides and pull to remove the Guardrail.
Seat Snap Buttons:
Check both sides of the seat fabric to ensure it is properly attached.
Seat Fabric Support:
Check the straps underneath the seat are both pulled tightly and are properly
attached with the Velcro fasteners.
Canopy Fabric:
Check the canopy is securely attached to the seatback with the Velcro
fasteners.
WARNING:
DO NOT use the product if there is any irreparable damage.
Use replacement parts provided ONLY by Besrey.
Regularty check your stroller for loose screws, worn parts, tom material or
stitching.
CARE AND CLEANING
Cleaning Seat Pad:
- Spot clean ONLY
- Surface wash small spots with a mild solution of soap and water
- Rinse with water to remove the soap solution
- Wipe or air dry
Cleaning Stroller:
- Wipe or air dry
- Wipe surfaces with water to remove the soap solution
- Surface wash stroller frame, plastic parts, and fabric with a mild solution of soap and water
besrey
www.besrey.com
support@besrey.com
Mon-Fri, 8 am – 6 pm PST
FUJIAN BESREY BABY PRODUCTS CO., LTD.
Made in China
Importer: STIGER, INC.
Address: 1370 VALLEY VISTA DR. STE 200-208 DIAMOND BAR, CALIFORNIA
91765-0208, UNITED STATES OF AMERICA