Mattel HRR48-4B70 Minecraft Exploding RC Creeper Instruction Manual

June 4, 2024
Mattel

Mattel HRR48-4B70 Minecraft Exploding RC Creeper Instruction Manual
Mattel HRR48-4B70 Minecraft Exploding RC Creeper

Adult supervision is recommended when the RC figure is being operated.
Please keep these instructions for future reference as they contain important information.
SymbolIMPORTANT: Please read all instructions before operating your RC figure

FEATURES

  • A JOYSTICK
    Feature

  • B ACTION BUTTON

  • C LED INDICATOR

  • D BATTERY BOX
    Feature
    BOTTOM VIEW

  • E EXPLOSION PARTICLES STORAGE SLOTS
    Feature

  • F LED LIGHT

  • G BATTERY BOX
    Feature
    BOTTOM VIEW

  • H POWER SWITCH

SET UP

A. BATTERY INSTALLATION

Battery Installation
Battery Installation

  1. Unscrew the battery covers on both the figure and the remote controller with a Phillips head screwdriver (not included).
  2. Install 3 AA (LR6) 1.5V alkaline batteries (not included) in the figure’s battery box.
  3. Install 2 AAA (LR03) 1.5V alkaline batteries (not included) in the remote controller’s battery box.
  4. For best performance, use alkaline batteries.
  5. Replace both battery covers and tighten screws.
  6. Replace the batteries in the figure and the remote controller if the figure begins to run slowly or does not respond or if the figure’s lights and sounds dim and distort.

SET UP (CONTD.)

LOADING THE EXPLOSION PARTICLES

  1. Load the explosion particles into the slots on the figure.

  2. Close the figure’s sides.

  3. Reattach the figure’s head.
    Loading Explosion Particles

TIPS

  • Each storage slot can fit a maximum of 5 explosion particles.
  • Press and hold the action button to open the figure and detach the head if the figure is already closed before loading the explosion particles.

PAIRING THE REMOTE CONTROLLER AND FIGURE

  1. Slide the power switch to ON (I) on the figure.

  2. Push the remote controller’s joystick forward or backward after switching on the figure.

  3. Pairing is complete when the LED changes from flashing red to solid red on the remote controller.

NOTE: If the figure does not respond to the remote controller after pairing, switch the figure off then back on to try pairing again or replace the batteries in the figure and remote controller if the batteries are drained.

Pairing
Pairing Remote Control
Pairing is complete
Pairing Remote Control

TIP: The figure will go into sleep mode if left idle for approximately 15 minutes to preserve battery life. To resume normal play, slide the figure’s power switch to OFF then ON again, and then push the remote controller’s joystick forward or backward to pair the figure and remote controller

TO PLAY

CHECKLIST

  • Are the remote controller and figure equipped with fresh batteries?
  • Is the remote controller paired with the figure?

CONTROLS

  • FORWARD
    Controls

  • REVERSE & TURN
    Controls

    • Press the action button for lights and sounds
      Controls

    • Press and hold the action button to explode!

NOTE
Operating range of the remote controller is up to 30 m (98 ft).

WARNING: Do not aim at eyes or face. Only use projectiles supplied with this toy. Do not fire at point blank range.
Company logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals