Bestway 68090 Pavillo Activemount 3 Tent Owner’s Manual

: June 3, 2024
: Bestway

Table of Contents

INTRODUCTION
ASSEMBLY
DISASSEMBLE AND MAINTENANCE
STORAGE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

68090 Pavillo Activemount 3 Tent
Owner’s Manual

INTRODUCTION

Proper Use
Any use other than that described or any modification of the product is not permissible and may result in injury and/or damage to the product. The manufacturer is not liable for damage caused by improper use. The product is not intended for commercial use.

Description of parts and features

Bestway 68090 Pavillo Activemount 3 Tent - parts

Tent Dimensions：
Inner tent: 220cm x 205cm x 120cm
Outer tent: (210+140)cm x 240cm x 130cm
Pitching dimension: 360cm x 250cm

Bestway 68090 Pavillo Activemount 3 Tent - Dimensions

WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this tent fabric. We recommend that you always position your tent upwind from a campfire. This will reduce the chances of having embers land on your tent. In case of fire, please find the exit to escape from the fire.
Never set up the tent near the river, under a tree or other objective hazards.
Keep exits clear.
Make sure ventilation openings are open all the time to avoid suffocation.
SAVE THESE INSTRUCTIONS

Choose a suitable site
Removing any sharp objects, which might damage the groundsheet.

ASSEMBLY

Setting up the tent

Bestway 68090 Pavillo Activemount 3 Tent - ASSEMBLY

WARNING: Poles contain fiberglass. We strongly recommend wearing gloves during assembly to avoid irritating hands.

Lay the outer tent on the ground, pull the four corners outwards
Note: make sure that channels for the poles are faced upwards
Note: make sure that the zip on the entrance to the tent is closed

Push the poles completely into the channels(FIG 1)

Stand the outer tent up and push the ends of the poles into the metal loops of outer the tent (FIG 2)

Push the end of the completely into the channel on the awning of the outer tent(FIG 3)

Secure the outer tent by pushing the tent pegs into the ground loops(FIG 4)

Tie one end of the guy ropes onto the four corner hoops of the outer tent FIG 4

Tie the other end onto the tent pegs and fasten them by inserting the tent pegs into the ground(FIG 4)

Hang inner tent by toggle and loops (FIG 5)

Note: Ensure that guy ropes are about at an angle of 45°

Do not pull the guy ropes too tight.

DISASSEMBLE AND MAINTENANCE

Follow steps 1-10 in reverse order.

Clean the tent and remove any stains with a sponge and cool water. Please use non-detergent soap for serious cleaning.
Never machine wash or machine dry the tent. Hand wash and air dry.
Please allow all parts to dry thoroughly before you repack the tent. This will prevent the formation of mold, bad odors, and discoloration
Stitch with thread to repair minor leaks, fabrics, and plastic sheet damage. Use ropes to connect broken frame parts.
Use tapes to repair the coating broken parts.
Silicone spray could be used on zippers if the stick