SEG 10ft Backlit Trade Show Display Instruction Manual
- June 1, 2024
- SEG
Table of Contents
SEG 10ft Backlit Trade Show Display
Components
| Component | Quantity |
|---|---|
| 1. Profile Bar w/ LED Stripe (x6) | 6 |
| 2. Profile Bar w/ Cable (x2) | 2 |
| 3. Profile Bar without Cable (x2) | 2 |
| 4. Inner Strut (x7) | 7 |
| 5. Base Plate (x2) | 2 |
| 6. Bottom Connector (x2) | 2 |
| 7. Side Connector (x4) | 4 |
| 8. Corner Connector (x2) | 2 |
| 9. Middle Cross Connectors (x2) | 2 |
| 10. Connecting Cable (x4) | 4 |
| 11. Power Supply w/ Device Plugin (x2) | 2 |
| 12. Soft Travel Case | 1 |
| 13. Graphic | 1 |
Assembly Steps
- Assemble The Frame Assemble the 3 bottom profile bars w/ LED lights using the bottom connectors on base plates, and connecting cable.
- Assemble The Frame Add a Profile Bar with Cable to each side of the display. Also add 2 Inner Struts to the lower half of the assembly.
- Assemble The Frame Add Side Connectors, Inner Strut and Middle Cross Bar to complete the horizontal support section.
- Assemble The Frame Complete the assembly by adding the remainder of the pieces.
- Connect Power Supply Connect the power supply to the bottom of the profile bar.
- Install The Graphic Install graphics by firmly pushing the silicone edge into the channel on the frame of the frame. Keep tension on the graphic as you go down each side so that there is enough fabric to reach the end.
Storage & Care
Store in a cool dry location. Clean hardware with a damp cloth. Machine wash the graphics in cold water on a gently cycle. Air dry only. Use a steamer for wrinkles. Never dry-clean.
FAQ
How many LED strips are included?
Six profile bars with LED strips are included.
What should I use to clean the hardware?
Use a damp cloth to clean the hardware.
Can the graphic be machine washed?
Yes, machine wash the graphics in cold water on a gentle cycle and air dry only.
What is the recommended method for removing wrinkles from the graphic?
Use a steamer to remove wrinkles from the graphic.
Is it safe to dry-clean the graphic?
No, you should never dry-clean the graphic.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>