GUOKAI 866-2401S Toy Car Instruction Manual
- June 1, 2024
- GUOKAI
Table of Contents
GUOKAI 866-2401S Toy Car
Product Information
- Specifications:
- Compliance: FCC regulations
- Radiation Exposure Limits: Set forth for an uncontrolled environment
- Operating Conditions: Must not be co-located or operating with any other antenna or transmitter
Product Usage Instructions
- Installation:
- Ensure the equipment is placed in a well-ventilated area.
- Avoid placing the transmitter near other antennas or transmitters.
- Connect the equipment following the provided instructions.
- Operation:
- Power on the equipment using the designated switch/button.
- Follow the user manual guidelines for proper usage.
- Avoid making any changes or modifications without approval.
- Maintenance:
- Regularly clean the equipment using a soft cloth.
- Avoid exposing the equipment to extreme temperatures or moisture.
- Refer to the user manual for any specific maintenance requirements.
FAQs
- Q: Can I place the transmitter near other antennas?
- A: No, the transmitter must not be co-located with any other antenna or transmitter to comply with FCC regulations.
- Q: How often should I clean the equipment?
- A: It is recommended to clean the equipment regularly using a soft cloth to maintain optimal performance.
866- 2401S / 2402S / 2403S / 2404S / 2405S / 2406S / 2407S / 2408S / 2410S / 2411S / 2412S/ 2413S / 2415S / 2416S / 2417S / 2418S / 2419S / 2420S / 2421S / 2422S / 2423S / 2424S / 2425S / 2426S / 2427S / 2428S / 2429S / 2805S / 378H2S / 378H2HUTS / 378H3S / 378H3TS / 2201S
WARNING:
- Never recharge non-rechargeable batteries.
- Always remove exhausted batteries from the product.
- Do not mix old and new batteries.
- Do not mix different types of batteries.
- Only use the recommended type of battery.
- Always insert the batteries using the correct polarity.
- Always remove exhausted batteries from the product.
- Do not short-circuit terminals.
- Batteries are to be changed by an adult.
- It is advisable to remove batteries from the unit if the. product is not to be used for long periods.
CAUTION:
- Do not operate this model in the vicinity of another model using the same frequency.
- Otherwise, radio signals may interfere with each other and the model cars may become out of control, causing accidents
- Use the alkaline battery and rechargeable battery correctly.
- Always turn off the power of the model car and the remote controller in sequence after use.
- If this model is to be stored for a long time, all batteries in the model car and the remote controller should be removed to avoid battery leakage.
To load the battery on the controller
(Please use it under the guidance of an adult)
- Open the battery cover on the controller in the direction as shown in.
- Set the 2X1.5V battery in the correct direction.
- Replace the battery cover on the controller in the direction as shown in.
Installation
Installation of car body batteries group
- (Please use it under the guidance of an adult) Unscrew the battery cover with a plus driver, press the buckle, and open the cover.
- Set 3X1.5V batteries in the correct direction.
- Replace the battery cover and fix it with a screw.
Operating Instruction
FCC
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used per the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>