DiGGiNGSOUND T002-01 Harbors Rechargeable Canceling Bluetooth User Manual

June 1, 2024
DiGGiNGSOUND

DiGGiNGSOUND T002-01 Harbors Rechargeable Canceling Bluetooth

Warm tips
For a better hearing experience, you will need about 1 -2 months to get used to the hearing aids.

READ BEFORE USE

If devices whistling, please do as follows:

  1. When the power indicator on charging case is below 10, please charge it.
  2.  Clean your ear canal before wearing.
  3. Chose and change earbuds to fit your ear canal.
  4. Hearing aids should be worn in the correct direction and tightly fitted.
  5. Make sure nothing cover on microphone.
  6. . Adjust the volume by one tap from “level 2” and increase gradually.

WHAT INCLUDED

  1. Charging Case
  2. Hearing Aids
  3. Sets Silicone Domes
  4. Cleaning Tool
  5. Type-c Charging Cable

HOW TO WEAR CORRECTLY

  1. Clean your ear canal before wearing.
  2. Take out and hold the long handle of hearing aids with your index and thumb finger.
  3. Wear the devices and adjust them to fit snugly in your ear canal(the long handle point to your mouth). (If whistling, please replace the earbuds.) 10o_ 15o

Tips: Using proper earbuds and wearing them correctly helps avoid squealing.

TIPS FOR REPLACING EARBUDS

Model A
Bowl Shape Earbuds

  1. Flip out the edge of the earbuds
  2. Install earbuds onto the hearing aids
  3. Restore the edge of the earbuds
    DiGGiNGSOUND-T00-01-Harbors-Rechargeable-Canceling-Bluetooth
\(3\)

Model B
Special Shape Earbuds

  1. Distinguishing earbuds’ bumps

  2. Flip out the edge of the earbuds

  3. Install earbuds onto hearing aids

  4. Place the earbuds’ bumps against the holes

OPERATION TOUCH COMMANDS

  • Auto Turn ON/OFF:
    Take out of the charging case/put back to the charging case and close the lid

  • Manual Turn ON/OFF:
    Long press 3s/Long press 6s
    Note: Wait for about 1 Os then the hearing aids work.

PHONE CALL

Answer the phone
(Single Touch)

Hang up the phone
(Long press 2s)

Reject the call
(Long press 2s)

INDICATOR LIGHT DESCRIPTION

  • Blue:
    Working

  • Red:

  1. Low power
  2. The left and right headphones not pairing
  3.  Charging

Note: below When 10, the battery charging bar falls case is no longer working.
You need to turn on/off manually.

How to right solve the headphones problem can’t that be the paired left ?
Put both hearing aids back to the charging case, long press the reset button until red light turn Blue.
If using, any please abnormalities put them occur back duringand press the reset button.

LEVELS HEARING LOSS ADJUSTMENT

DiGGiNGSOUND-T00-01-Harbors-Rechargeable-Canceling-Bluetooth
\(14\)

BLUETOOTH CONNECTION

  1. Turn on the device’s Bluetooth search.
    DiGGiNGSOUND-T00-01-Harbors-Rechargeable-Canceling-Bluetooth
\(15\)

  2. Open the charging case, the devic will automatically enter Bluetooth pairing mode. 

  3. Select  from the Bluetooth list of your device and click to connect.

SPECIFICATIONS

DiGGiNGSOUND-T00-01-Harbors-Rechargeable-Canceling-Bluetooth
\(1\)

FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

Thank you for choosing Diggingsound!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals