YJBCO V2-L Dual Color LED Controller User Manual
- June 4, 2024
- YJBCO
Table of Contents
YJBCO V2-L Dual Color LED Controller
Feature
- 4096 levels 0-100% dimming smoothly without any flash.
- Match with all RF 2.4G single zone or multiple zone dual color or single color remote control.
- One RF controller accept up to 10 remote control.
- Auto-transmitting function: Controller automatically transmit signal to another controller with 30m control distance.
- Synchronize on multiple number of controllers.
- Fade in and out effect selectable.
- 3 levels color temperature (WW, NW and CW) selectable by continuous power off and on operation.
- Connect with external push switch to achieve on/off and 0-100% dimming function.
- Over-load / Short circuit protection, recover automatically
Technical Parameters
Mechanical Structures and Installations
**Wiring Diagram
**
Match Remote Control (two match ways)
Use the controller’s Match key
Match:
Short press match key, immediately press on/off key (single zone remote) or
zone key (multiple zone remote) of the remote. The LED indicator fast flash a
few times means match is successful.
Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast
flash a few times means all matched remotes were deleted.
Use Power Restart
Match:
Switch off the power, then switch on power, repeat again. Immediately short
press on/off key (single zone remote) or zone key (multiple zone remote) 3
times on the remote. The light blinks 3 times means match is successful.
Delete:
Switch off the power, then switch on power, repeat again.
Immediately short press on/off key (single zone remote) or zone key (multiple
zone remote) 5 times on the remote. The light blinks 5 times means all matched
remotes were deleted.
Application notes
- All the receivers in the same zone.
- Auto-transmitting: One receiver can transmit the signals from the remote to another receiver within 30m, as long as there is a receiver within 30m, the remote control distance can be extended.
- Auto-synchronization: Multiple receivers within 30m distance can work synchronously when they are controlled by the same remote.
- Receiver placement may offer up to 30m communication distance. Metals and other metal materials will reduce the range.
- Strong signal sources such as WiFi routers and microwave ovens will affect the range.
- We recommend for indoor applications that receiver placements should be no further apart than15m.
- Each receiver(one or more) in a different zone, like zone 1, 2, 3 or 4.
Push Dim with Synchronization
- The provided Push-Dim interface allows for a simple dimming method using commercially available non-latching (momentary) wall switchs.
- If more than one controller are connected to the same push switch, do a long press for more than 10s, then the system is synchronized and all lights in the group dim up to 100%.
- This means there is no need for any additional synchrony wire in larger installations.
- We recommend the number of controllers connected to a push switch does not exceed 25 pieces,
- The maximum length of the wires from push to controller should be no more than 20 meters.
Dual color control
- WW=Warm white LED
- CW=Cool white LED
Each channel can supply up to 192W(@24V) and white balance can be controlled
as such:
Fade in and Fade out Setting
- Long press match key 5s, then short press match key 3 times,
- The lighting effect will be set to the fade in and fade out in 3s, the indicator light of LED controller blinks 3 times.
- Long press match key 10s, restore factory default parameter, the light on/off time restores to 0.5s.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>