PANTAZO Wooden House Large Space Cat Cage Installation Guide

PANTAZO Wooden House Large Space Cat Cage

HARDWARE

DIMENSION

ASSEMBLY INSTRUCTION

1. Install the embedded nut
2. Install the link rod
3. The effect after installation is shown in the figure
4. Install the eccentric wheel
5. Tighten with a screwdriver

6. Check if the item is complete
7. Place the holes as shown in the drawings
8. Fix the screw first according to the installation method of the three in one screw

9. Place the back plate flat and locate the inner 123 plate Insert it into the hole and fix it with an eccentric wheel
10. Insert the engraving plate and locate the inner 123 plate. into the hole as shown in the Insert it into the hole and fix figure and install it with an it with an eccentric wheel eccentric wheel
11. When installing the side panel sey are anonte the eccentric wheel gu
12. Install the top and bottom plates according to the hole positions

13. Install the wheel and fix the universal wheel to the base plate with 1.5cm screws
14. After the Wheel Installation is completed, stand up the cabinet, tighten the eccentric wheel behind the back plate, and fix the side plate to the back plate
15. Thread the suspension bridge rope through the hole from bottom to top
16. Install the cat grab post and fence as shown in the figure, and fix them to the corresponding positions with 3cm screws

17. Install the bottom ladder, first fix the hinge with 1.5cm screws and the ladder, and then fix the ladder on the floor board
18. Install the access door and link it with a 1.5cm screw
19. Install the glass door. The first step is to install the metal plug onto the bottom plate hole, and then install the class hinge into the metal pluc
20. Clip the glass into the hinge, with the outer edge of the glass level with the outer edge of the hinge. Note: Place shims on both sides and tighter with a screwdriver

21. Clip the glass on top into the hinge, with the outer edge of the glass level with the outer edge of the hinge. Place shims on both sides andtighten with a screwdriver
22. Install the locking iron plate, align it with the hole position, and fix it with the shortest screw
23. Install the door lock at the bottom of the right glass, adjust the lock tongue and place a gasket on the corresponding lock hole, and tighten it with a screwdriver
24. Install the door stopper, first close the right glass door, determine the position of the door stopper, and fix it on the top plate with 3CM screws

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>