THOR KITCHEN TWD3001 30 Inch Built In Warming Drawer Oven User Manual
- June 3, 2024
- Thor Kitchen
Table of Contents
- TWD3001 30 Inch Built In Warming Drawer Oven
- SAFETY PRECAUTIONS
- WARMING DRAWER FEATURES
- WARMING DRAWER OPERATION
- CARE RECOMMENDATIONS
- TROUBLESHOOTING
- PRODUCT DIMENSIONS
- INSTALLATION DIMENSION
- ACCESSORIES
- INSTALL HANDLE
- TROUBLESHOOTING AND INFORMATION CODES
- WARRANTY
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
PROFESSIONAL WARMING DRAWER
COOK LIKE A GOD
TWD3001
User & CARE Manual
TWD3001 30 Inch Built In Warming Drawer Oven
IMPORTANT NOTE
To ensure this product is installed and operated as safely and efficiently as
possible, take note of the following types of highlighted information
throughout this guide:
IMPORTANT NOTE highlights information that is especially important.
CAUTION indicates a situation where minor injury or product damage may
occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or death if
precautions are not followed.
IMPORTANT NOTE: Throughout this guide, dimensions in parentheses are
millimeters unless otherwise specified.
SAFETY PRECAUTIONS
GENERAL SAFETY REQUIREMENTS
- Read this use & care guide carefully before using your new warming drawer to reduce the risk of fire, electric shock, or injury to persons.
- To protect against electrical shock do not immerse the cord or plug in water or other liquid.
- The use of accessory attachments not recommended by the appliance manufacturer may cause injuries.
- Do not repair or replace any part of the warming drawer unless specifically recommended in the literature accompanying this appliance. All services should be referred to Thor Group Certified Service.
- Close supervision is necessary when any appliance is used by or near children.
- Do not use outdoors (model TWD3001).
- Do not use appliances for other than intended use.
- Do not touch the heating element or the interior surface of the warming drawer. These surfaces may be hot enough to burn. The inside surfaces of the warming drawer may be hot when opened.
- Do not use aluminum foil to line the warming drawer. This may cause damage to the interior sur- faces of the warming drawer.
- Do not heat unopened food containers, such as baby food jars and cans. Pressure from the build-up may cause the container to burst and cause injury.
- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
- Ensure that towels are stacked only as high as the sides of the drawer pan. Any higher may result in discoloration of the towels.
- Do not place more than 50 lb (20 kg) into the warming drawer.
WARMING DRAWER FEATURES
FEATURES
- Pan support rail locator notch
- Removable Rack
- Control panel
- Drawer Pan
- Drawer side
- Drawer rail
WARMING DRAWER OPERATION
CONTROL PANEL
The electronic control panel features touch controls and a visual display. Refer to the illustration below. The control panel is hidden when the warming drawer is closed. Open the drawer to access the control panel.
TEMPERATURE
The warming drawer features four preset temperature settings; KEEP WARM, PROOF
PLATES, and CUPS. During preheating, the temperature display will alternate
between the set point and the actual temperature. ‘Proof’ will appear until
the temperature reaches 85°F (30°C). An audible chime indicates that preheat
is complete. Refer to the chart below.
Setting | Min temperature | Max temperature | Default |
---|---|---|---|
Bread Proof | 85°F(30°C) | 105°F(40°C) | 85°F(30°C) |
Keep Warm | 150°F(65°C) | 185°F(85°C) | 170°F(75°C) |
Plates | 140°F(60°C) | 175°F(80°C) | 150°F(65°C) |
Cups | 105°F(40°C) | 140°F(60°C) | 125°F(50°C) |
TIMER
Bread Proof: The default working time is 4 hours. The maximum is 12
hours.
Keep Warm: The default working time is 2 hours. The maximum is 5 hours.
Plates: The default working time is 3 hours. The maximum is 12 hours.
Cups: The default working time is 3 hours. The maximum is 12 hours.
Setting timer:
- Select desired temperature.
- Touch the TIMER UP or DOWN arrows to select the desired time (one gear every 15 minutes). ‘TIMER’ and the shut-off time will appear in the display.
CARE RECOMMENDATIONS
CLEANING
Stainless steel
Use a nonabrasive stainless steel cleaner and apply with a soft lint-free
cloth. To bring out the natural luster, lightly wipe the surface with a water-
dampened microfiber cloth followed by a dry polishing chamois.
Always follow the grain of stainless steel.
The stainless steel drawer pan is removable for cleaning. To remove, open the
drawer completely. Slide fingertips underside edges of the pan and pull up and
out.
Control panel
Use a spray degreaser to remove fingerprints and food soil. Spray on a cloth
before wiping the panel.
Do not spray cleaners directly on the control panel.
Removable Rack
Clean with hot water and mild detergent or paste of baking soda and water.
Towel dry.
Interior
Wipe with a soft damp cloth. Do not use abrasive or harsh cleaners or scouring
pads.
For heavier soil, use baking soda or a mild soap; rinse thoroughly with hot
water.
Drawer Guides
Remove food crumbs from drawer guides. Wipe with a soft dry cloth.
Note: THOR KITCHEN warming drawer is equipped with a food-grade silicone
pad at the bottom of the drawer, which can be easily cleaned.
TROUBLESHOOTING
THE WARMING DRAWER DOES NOT OPERATE.
- Verify power is on.
- Verify electrical power to the warming drawer and home circuit breaker is on.
THE DRAWER DOES NOT SLIDE SMOOTHLY.
- The drawer is out of alignment. Fully extend the drawer and close it completely to realign.
- The drawer is overloaded. Reduce weight to less than 50 lb (20 kg) .
- Redistribute contents to balance the load.
EXCESSIVE CONDENSATION.
- Remove liquid in the drawer pan.
- Cover food with lid or aluminum foil.
- The temperature setting is too high. Use a lower setting.
NO HEAT IN THE PROOF SETTING.
- Verify PROOF is illuminated on the control panel display.
- Room temperature may prevent the thermostat from turning on. Food dries out in proof sets.
- Cover food with a lid or aluminum foil.
PRODUCT DIMENSIONS
INSTALLATION DIMENSION
CABINET FRONT VIEW
WARMING DRAWER SIZE| MINIMUM BETWEEN CUTOUTS (A)| CUTOUT HEIGHT
(B)| MINIMUM/
RECOMMENDED (C)| CUTOUT WIDTH (D)| MINIMUM CABINET WIDTH (E)
---|---|---|---|---|---
30″| 21/2″| 91/8.| 1″ (2.5 cm)/| 281/2•| 30″
(76.2 cm)| (6.4 cm)| (23.2 cm)| 41/41 (10.8 cm)| (72.2 cm)| (76.2 cm)
The warming drawers can be installed as an indoor single or double
installation or installed under a single oven. Two warming drawers under a
single oven are shown.
NOTE: The warming drawer cannot be leveled after being installed.
For outdoor installation follow the cutout dimensions above. Install the
outdoor warming drawer in a permanent fixture.
Custom Wood Drawer Front
If you plan to install a custom wood panel to match your cabinets, we
recommend consulting a qualified cabinetmaker or carpenter. The back of the
wood panel must be sealed to avoid moisture damage.
INSTALLATION DIMENSION
CLEARANCE DIMENSIONS – FLUSH INSTALLATION
| 30″ Models
---|---
A| Width of flush inset cutout (minimum)| 301/4″ (76.8 cm)
B| Height between cutouts (minimum)| 21/2″ (6.4 cm)
C| Height of flush inset cutout (minimum)| 10N” (27.3 cm)
D| Bottom of the cutout to the floor (recommended)| 81/4″ (21.0 cm)
Bottom of the cutout to the floor (minimum)| 5″ (12.7 cm)
E| Width of opening (minimum)| 281/4″ (71.8 cm)
F| Depth of cutout (minimum)| 25%” (64.5 cm)
e| Recommended outlet location|
INSTALLATION DIMENSION
Fix the anti-tilt fixing plate on the back wall with screws according to the size shown in the figure. After the product is pushed in, Fix it with screws at the screw hole in the front of the product.
ACCESSORIES
INSTALL HANDLE
-
How to install Handles For Thor KD Models.
-
Connect the handle to the handle holders.
-
Lay the door handle against to the oven door and fit it on the connection part.
-
Use the wrench to get the door handle holder tinght.
-
Check if the oven door is level and stable.
TROUBLESHOOTING AND INFORMATION CODES
ERROR CODE | AFTER-SALES SERVICE |
---|---|
Er00 | Temperature detection failure. |
Er01 | Door switch detection failure. (Or there is a foreign body stuck so that |
the door cannot be closed but the function is turned on)
Er02| The convection fan does not work.
Er03| No heating.
Er04| The temperature is too high.
Er05| Touch button detection failure.
ErPF| Power failure, when the warming drawer has been working for a period of
time, the PF error code is displayed, indicating that there was a power
failure during the work, and the warming drawer will not continue to work but
display PF
WARRANTY
Warranty and Service
This product has been manufactured by Thor Group, 4651 E Airport Drive,
California 91761 For Customer Service, please call (877) 288 – 8099
For the most up-to-date warranty and service policy, please refer to our
website WWW.THORKITCHEN.COM/WARRANTY-REGISTRATION
For in-warranty service requests, please visit our website at
WWW.THORKITCHEN.COM/SERVICE
Please Note: You must provide proof of purchase or installation date for
any in-warranty service requests
WELCOME
TO THE CLUB
You chose THOR Kitchen to enhance your culinary journey and we’re stoked to
have you in the club. Think of it as a secret society of really savvy people,
such as yourself, choosing professional power and performance at an affordable
price.
Register your product by following the steps below.
WARRANTY REGISTRATION
Scan the code or visit
thorkitchen.com/warranty| Input your
product info and select register| You’re done. Let’s get cookin’.
|
---|---
https://qrco.de/bc8xkY| https://qrco.de/bd83dz
thorkitchen.com /# COOKLIKEAGOD
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>