RUBBERDUCK BATHROOMS 10922L Bathtub Overflow Cover Instruction Manual
- June 1, 2024
- RUBBERDUCK BATHROOMS
Table of Contents
RUBBERDUCK BATHROOMS 10922L Bathtub Overflow Cover
Product Information
Specifications:
- Suitable for bathtub thickness: 5-15mm
Product Usage Instructions
-
Installation:
Ensure that the bathtub thickness falls within the specified range of 5-15mm before proceeding with installation. The plug and washer need to be supplied by the user. -
Testing for Leaks:
After installation, perform a test to check the overflow pipe for leaks. This step is crucial to ensure proper functioning and prevent water damage. -
Aftercare:
It is essential for the end user to regularly maintain and clean the product to keep it in optimal condition. Use warm soapy water and a soft cloth for cleaning. Avoid using corrosive or abrasive agents on the surface finish as this may void the product warranty.
FAQ :
-
Q: How often should I clean the product?
A: It is recommended to clean the product regularly using warm soapy water and a soft cloth to maintain its appearance and ensure the warranty remains valid -
Q: Can I use abrasive cleaners on the surface?
A: No, abrasive cleaners should be avoided as they can damage the surface finish and invalidate the product warranty. Stick to gentle cleaning methods.
Assembly Instructions
Installing steps
- identify all components are present prior to installation
- Flush pipes to remove any debris in pipes before installation
- Position overflow body (C). Ensure washers (Item D and E) are in place and push the overflow cover (A) into lock nut (B)
- Assemble waste outlet (J), Ensure washers (Items H and I) and Flange (G) are in place and tighten.
- Fill the bath with water and check all joints to ensure there are no leaks, This is best done in stages starting with a small amount of water before fully filling the bath
- Once fitting has been completed carefully clean all plated surfaces. The finished surface product should be cleaned on a regular basis to maintain their appearance. The product should only be cleaned with warm soapy water and then wiped with a dry cloth
- Overflow cover
- B Lock nut
- C Overflow body
- D Flat washer-lock nut
- E Flat washer-overflow
- F Cover
- G Flange
- H Washer
- I Washer
- J Waste outlet
- K Rubber seal
- L Plastic spacer
- M Plastic nut
- N Plastic pipe
Once assembled, fill the bath with water, check for leaks.
Product is suitable for bathtub thickness 5-15mm
Plug and washer
supplied by user. Test purpose is to check the overflow pipe for leaks.
Aftercare:
- The end user is required to regularly maintain and clean product using warm soapy water and a soft cloth for the product warranty to be valid.
- Surfaces should be maintained using a clean damp cloth, NO corrosive and abrasive agents or materials should be used or come into contact with the surface finish, as this will invalidate your product warranty.