PERGOLUX S2 SKYDANCE Remote Control Instruction Manual
- June 1, 2024
- PERGOLUX
Table of Contents
REMOTE CONTROL S2
PERGOLUX SKYDANCE
Operating instructions for remote control and electronics
S2 SKYDANCE Remote Control
Operating instructions for the remote control
The remote control has six channels that can be used to control various
functions or accessories.
The selected channel is displayed at the top of the remote control with , the
channels 1-6. You can switch between the channels using the arrows Channel
1: LED control
When channel 1 is lit, the LED lighting can be switched on by pressing the up
arrow. When the LEDs are turned on, the brightness of the LED lighting can be
dimmed by pressing the down arrow To switch off the lighting, press the square
button in the middle of the remote control.
Channel 2: Louvres
When channel 2 is lit, the slats can be opened by pressing the down arrow and
closed by pressing the up arrow. If the down arrow or the up arrow is pressed
for three seconds the slats close or open completely.
If the square button is pressed during opening or closing the slats stop.
Channels 3 to 6: are free and not assigned to any function. The HEATER
can be connected to any of these channels.
Changing the battery: at the bottom of the back of the remote control
remote control, the battery cover can be pushed down to remove the battery.
Storage: only store the remote control in a dry place. Remove the battery
if the remote control will be inactive for more than 4 weeks.
SAFETY INSTRUCTIONS: Make sure that there are never people or objects
between or in the vicinity of the slats when they are in motion! There is an
acute risk of injury! Never leave children unattended!
Disconnecting and Connecting the Remote to the Control Box
Below you can see a diagram of the structure of the control unit, which is
used to the connection to the remote control is established and the remote
control. Familiarize yourself with the setup in order to continue with the
next steps.
Unpairing the connection
- Open the access panel in the beam of the PERGOLUX SKYDANCE, the control unit is located behind it. The Control Box is located inside the beam for Sundream and Pergola (LEDs)
- Now press and hold the corresponding LED indicator light on the control unit for 7 seconds.
The LED will begin to flash slowly, continue holding the button and as soon as the LED light flashes quickly, the connection to the remote control is deleted.
Recoupling the connection
- Select the corresponding channel on the remote control (1 for LED lighting and 2 for slats)
- Press and hold the corresponding button on the control unit for 4 seconds
- When the LED indicator on the control unit flashes quickly, it is in programming mode.
- Press the up arrow on the remote control – the LED display on the control unit should now flash once.
- The remote control is now programmed to the corresponding function.
SAFETY INSTRUCTION: Make sure that there are never people or objects
between or near the slats when they are in motion! There is acute risk of
injury! Never leave children unattended!
If you have any further questions about proper use, please contact customer
service. We will be more than happy to help!
CHANGING LED-LIGHT COLOUR
REMOTE CONTROL S2
Documents / Resources
|
PERGOLUX S2 SKYDANCE Remote
Control
[pdf] Instruction Manual
S2 SKYDANCE Remote Control, S2, SKYDANCE Remote Control, Remote Control,
Control
---|---