REMINGTON AS7300 Blow Dry and Style Caring 800W Airstyler Instruction Manual
- June 3, 2024
- Remington
Table of Contents
REMINGTON AS7300 Blow Dry and Style Caring 800W Airstyler
Thank you for buying your new Remington® product. Please read these
instructions carefully and keep them safe. Remove all packaging before use.
WARNING: This appliance is hot. Keep out of reach of children at all
times.
IMPORTANT SAFEGUARDS
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.
Do not use this appliance near bathtubs, showers, basins or other vessels containing water. -
When the appliance is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the appliance is switched off.
-
For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom*.
-
Currently, the fitting in a bathroom of an electrical socket suitable or capable of operating the appliance is not permitted in the UK (see BS7671).
- If the supply cord of this unit becomes damaged, discontinue use immediately and return the appliance to your nearest authorised Remington® service dealer for repair or replacement in order to avoid a hazard.
- Always ensure the voltage to be used corresponds to the voltage stated on the unit before plugging the appliance into the mains socket.
- Keep direct airflow away from eyes or other sensitive areas.
- Do not allow any part of the appliance touch the face, neck or scalp.
- During use, always ensure the inlet and outlet grilles are not blocked in any way as this will cause the unit to automatically stop. If this should occur, switch off and allow the unit to cool.
- Keep the power plug and cord away from heated surfaces.
- Do not leave the appliance unattended while plugged in.
- Do not place the appliance on any soft furnishings.
- Do not use attachments other than those we supply.
- Do not set the appliance down while still on.
- Do not twist or kink the cable, or wrap it round the appliance.
- Do not use the appliance if it is damaged or malfunctions.
- Check the cord regularly for any sign damage.
- This appliance is not intended for commercial or salon use.
PARTS
- 800W power handle
- Speed/heat selector switch
- 25 mm brush
- 38 mm brush
- Pre-styling nozzle
- Removable inlet grille
- Hang up loop
- Swivel cord
INSTRUCTIONS FOR USE
Prepare the hair for styling
- Wash and condition the hair as normal.
- Squeeze out excess moisture with a towel and comb through.
- Using the pre-styling nozzle rough dry the length and roots until 80% dry.
- Divide the hair into sections, style the lower layers first.
To fit/remove attachments
Fit the attachment before you turn on the appliance.
CAUTION: Attachments can become hot during use, let them cool before
removing.
- To remove, twist the attachment until the markings line up as shown in figure A and pull it off the power handle.
- To fit an attachment, align the symbols on the power handle and attachment as shown in figure B then twist the attachment until it locks into place.
Speed and temperature settings
- Plug your styler in to the mains power supply.
- Turn your air styler on and select the appropriate setting for your hair by sliding the speed/heat selector switch.
- Your air styler has three settings:
- High heat/speed ( ): Thick and difficult to style hair.
- Low heat/speed ( ): Thin/fine, damaged or bleached hair.
- Cool ( ): Helps to set your style with cool air.
Create volume using the 38mm brush
- To dry your roots and add volume, place the brush underneath the section close to the roots and hold for a few seconds, lifting the hair as you dry.
- Move the styler downward through the hair section.
- Repeat this around the head.
- Let the hair cool before further styling.
Create shaped ends using the 25mm brush
- To curl the ends in, place the brush underneath the section close to the ends and rotatethe styler inwards allowing the hair to wrap around the barrel and hold for a fewseconds.
- To curl the ends out, place the brush on top of the section close to the ends and rotate the styler outwards allowing the hair to wrap around the barrel and hold for a few seconds.
- Repeat this around the head.
- Let the hair cool before further styling.
CLEANING AND MAINTENANCE
- After use, turn the appliance off by moving the temperature control switch to the O position.
- Unplug the appliance and allow to cool before cleaning and storing away.
- To maintain peak product performance and to prolong motor life, it is important to regularly remove any dust and dirt from the air filter grille and clean with a soft brush.
- To clean the area covered by the grille, twist it in the direction shown (Fig. C) and slide it down the cable. Clean the inside area then slide the grille back up the cable and twist it in the opposite direction until it locks.
- Don’t use harsh or abrasive cleaning agents or solvents.
Ref. No. AS7300Type No. AS19A
22/INT/ AS7300 T22-7002569 Version 04 /22
Remington® is a Registered Trade Mark of Spectrum Brands,Inc., or one of its
subsidiaries
Russell Hobbs Deutschland GmbH, Am Unisyspark 1, 65843 Sulzbach, Germany
remington-europe.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>