Pro PODS P61025 21 ⁄ 16 Inch Subaru WRX Instrument Cluster Bezel Instruction Manual
- June 17, 2024
- Pro PODS
Table of Contents
Pro PODS P61025 21 ⁄ 16 Inch Subaru WRX Instrument Cluster Bezel
Specifications
- Model: P61025
- Compatibility: 21/16 Subaru WRX
- Warranty: Auto Meter ProPods Three Limited Year Warranty
INSTALLATION INSTRUCTIONS
-
Remove the factory gauge bezel per the manufacturer’s instructions. Contact the auto manufacturer for details.
-
Remove the two factory screws at the bottom of the instrument cluster bezel and install the included aluminum brackets. Use outside holes to install for proper fit.
-
Install gauges in the cluster and run wiring.
-
Install Instrument Cluster Bezel
NOTE : Installing this Dash Pod with mechanical pressure gauges may require 12ft. nylon tubing kit model 3226 (not for use with fuel pressure gauges). 12ft. capillary tubing may also be needed on mechanical temperature gauges. -
Use the two factory screws to secure the top of the bezel, and the supplied screws to attach the Instrument Cluster Bezel to the aluminum brackets.
Warranty and Service
The product is covered by the Auto Meter ProPods Three Limited Year
Warranty. For service or any inquiries, please contact AUTO METER PRODUCTS
Inc. at the following address: 413 W. Elm St., Sycamore, IL 60178 USA
Auto Meter ProPods Three Limited Year Warranty
Auto Meter warrants to the consumer that all ProPod products will be free from
defects in material and workmanship. Products that fail will be repaired or
replaced at Auto Meter’s option to the consumer when determined by Auto Meter
that the product failed due to defects in material or workmanship. This
warranty is limited to the repair or replacement of parts in the ProPod
Product and the necessary labor done by Auto Meter to effect the repair or
replacement of the ProPod product. In no event shall this warranty exceed the
original purchase price of the ProPod Product nor shall Auto Meter be
responsible for special, incidental, or consequential damages or costs
incurred due to the failure of this product. Warranty claims to Auto Meter
must be transportation prepaid and accompanied by proof of purchase. This
warranty applies only to the original purchaser of the product and is non-
transferable. Improper use or installation, accident, water damage, abuse,
unauthorized repairs, or alterations void this warranty. Auto Meter disclaims
any liability for consequential damages due to breach of any written or
implied warranty on all products manufactured by Auto Meter.
FAQ
- Q: What should I do if I encounter flashing around the pod holes?
- A: The flashing is a normal part of the manufacturing process. Once you install the gauge(s) in the pod, the flashing will not be visible.
- Q: Are there any additional components required for installation?
- A: If you are using mechanical pressure gauges, you may need the 12ft. nylon tubing kit model 3226. However, please note that this kit is not suitable for fuel pressure gauges. Mechanical temperature gauges may also require 12ft. capillary tubing.
FOR SERVICE CONTACT: AUTO METER PRODUCTS Inc. 413 W. Elm St., Sycamore,
IL 60178 USA 866-248-6357 or
Email us at service@autometer.com
- Phone: 866-248-6357
- Email: service@autometer.com
© 2012 Auto Meter Products, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>