Winjet WJ1025-0612 Mustang Projector Headlights User Manual
- June 1, 2024
- Winjet
Table of Contents
Winjet WJ1025-0612 Mustang Projector Headlights
Product Information
Specifications
- Model: WJ1025-0612
- Compatible with: 2010-2012 Ford Mustang with halogen headlights models, 2010-2012 Ford Mustang Shebly GT500 with halogen headlights models
- Not compatible with: Factory equipped HID models
Product Usage Instructions
Required Tools
- Ratchet
- Wrench Extension
- Phillips Screwdriver
- Panel Remover
Installation Instructions
- Remove 8 plastic clips.
- Remove 3 bolts.
- Reuse the original signal bulb socket.
- Feed the harness through the frame.
- Connect the red wire behind the lamp.
- Aim the lamps using a Phillips Screwdriver. Clockwise for UP, Counterclockwise for DOWN.
- Reinstall the original removed parts and bolts.
Note: Follow the installation steps carefully to ensure proper installation of the headlights.
Frequently Asked Questions (FAQ)
Q: Can these headlights be installed on a Ford Mustang model with factory-equipped HID lights?
A: No, these headlights are not compatible with Ford Mustang models that come with factory-equipped HID lights. They are designed specifically for models with halogen headlights.
Q: Do I need any additional tools for installation?
A: The required tools for installation are listed in the user manual. Make sure you have a ratchet, wrench extension, Phillips screwdriver, and panel remover on hand before starting the installation process.
Model
- WJ1025-0612 2010-2012 Ford Mustang with halogen headlights models 2010-2012
- Ford Mustang Shelby GT500 with halogen headlights models
- NOT fit for factory-equipped HID models
REQUIRED TOOLS
Installation Instructions
- Remove 8 plastic clips
- Remove the front bumper cover
- Remove the front bumper cover
- Remove the 3 bolts and the clip that’s holding the headlight
- Unplug the Hi/Lo beam light bulb and remove the turn signal from the original headlight
- Plug in the Hi/Lo beam socket to the new Winjet headlight and install the turn signal plug to the Oem turn signal socket Remember to align the black wire ( negative ) to the side of the socket with the tab, and install the socket onto the Winjet headlight.
- Plug in the red wire from the headlight to the red wire that’s supplied by the package
- The red wire is for the DRL and it will need to be connected to an ignition source
- NOTE please consult a professional installer if you are not sure about the ignition source
- Install the new Winjet headlight and secure it with the 3 bolts and the clip
- Connect the red wire behind the lamp
- Aim the lamps by Phillips Screwdriver
- Reinstall the original removed parts and bolt.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>