YCNASSS ZSW-C09 Smart Table Water Dispenser Instruction Manual
- June 1, 2024
- YCNASSS
Table of Contents
Instruction Manual
Production Introduction
- Water outlet port
- Water outlet pipe
- Cup holder
- Water level light
- Water level keypad
- Power keypad’ Water outlet keypad
- USB charge pert
- Water intake
Selling Points
Product Parameters
Model. ……………………………………Z SW- CO9
Product Material …………………….. ABS
Rate INPUt ……………………………….. 5V 0.8
Battery Capacity …………………………. 1800 mAh
Power Jack ……………………………………TYPE – C
Product Weight ……………………….. 265g
Executive Standard : ………………. GB 4706 1-2005
Dimension ………………………………. 120x137x2 35mm
Product Instruction
Long press the water outlet button: Power on/off (Pumping gear is default to
last time setting when power on, sl[LED lights will be lighting together, also
battery level’s showing, all lights flash 3 times and then turn off)
Single click the water outlet keypad: Start Pump/Stop Pump
Single click the water level keypad: Shift mode setting (Add 1 level with
single press in cycle, there are total 7 levels and corresponding light are:
LOOML, 200ML, 300ML, 500ML, 700ML,
1000 ML and unlimitec flow, each gear has a corresponding light on, all LED
light on when unlimited flow; Low battery reminder: When battery is lower than
10%, the tight flashes quickly to remind charge on time lighting reminder of
corresponding gear)
Light 1s flash when charging and lights up after fully charged.
After standby 2 minutes, machine is going to sleep and turn off the light, at
this time, press any keypad to wake up and showing current gear light.
Specail Instruction
- This machine can only be used for pure water at 5-40 degrees celsius, please don’t use for gel liquid
- This machine 1s only prevent 10 spray water of life. please dont wash with water
- Water inlet pipe can’t be higher than dispenser to prevent dripping water from the water outlet
Installation Steps
- Water outlet align to this icon then press down and rotate to the left to this icon is OK.
- Install the bottom of water pipe and insert it into the corresoondmg position
Warranty Card
-
Since the date of purchase, if there is no man-made product failure, we will provide a half year’s free warranty.
-
Below circumstances are not included during warranty period:
a. Failures or damages that are caused by unauthorized disassemble and repair.
b. Failures caused by improper use, such as liquid injection, external force extrusion, falling damage etc.
c. Damage caused by natural disasters or irresistible factors. -
Please keep this warranty card well. ifyoucan’t provide this card, it will be deemed that the product has exceeded the warranty period, certain materials cost and repairing cost will be collected.
Thank you fou choosing this product Please read this manual carefully before using.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>