CAMBRIDGE AUDIO CXN100 Safety Artwork Instructions

CAMBRIDGE AUDIO CXN100 Safety Artwork

DO NOT PRINT THIS PAGE AS PART OF THE MANUAL!

PRINTING INSTRUCTIONS COVER SHEET

• Drawing Title
  • CA0930 SAFETY GUIDE ARTWORK (CXN100/EXN100 )
• Drawing No.
  • AP38425/2
• Print Colour
  • Greyscale / Black & White
• Material
  • 80gsm plain/normal paper
• Dimensions
  • Print A3 size (w 420mm x h 297mm)
• Special Instructions
  • Print on both sides, folded from A3 size poster down to 99x140mm (see pictures for printing instructions).
• Drawn By
  • Ivan——————
  • Checked By—————
  • Signed Off By———————–

Revisions & Date

1. 26.06.23: Original.
2. 11.09.23: Added RoHS description and both models on the SDOC.

Important safety instruction foldout sheet

IMPORTANT SAFETY INSTRUCTIONS

For your safety please read the following important safety instructions carefully before attempting to connect this unit to the mains power supply.

They will also enable you to get the best performance from and prolong the life of the unit:

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any ventilation openings. Install by the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades one wider than the other. A grounding-type plug has two blades and a third grounding prong.

   • The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for the replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use with only the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus.
    When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for long periods.

14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as the power-supply cord or plug having been damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

WARNING:

• Do not place the unit in an enclosed space; if you wish to place the unit on a shelf, use the top shelf to allow maximum ventilation. Do not put any objects on top of this unit.
• Do not situate it on a rug or other soft surface and do not obstruct any air inlets or outlet grilles. Do not cover the ventilation grilles with items such as newspapers, tablecloths, curtains, etc.
• To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. This unit must not be used near water or exposed to dripping or splashing water or other liquids.
• No objects filled with liquid, such as vases, shall be placed on the unit.
• The a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.
• The battery (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire, or the like.
• The unit must be installed in a manner that makes disconnection of the mains plug from the mains socket outlet (or appliance connector from the rear of the unit) possible.
• Where the mains plug is used as the disconnect device, the disconnect device shall remain readily operable.
• Please refer to the information on the exterior rear panel for electrical and safety information before installing or operating the apparatus.
• Only use the main cord supplied with this unit.
• Use of the apparatus in tropical climates
• The equipment shall be used at a maximum of 45 degrees C ambient temperature.
• The unit is of Class 1 construction and must be connected to a main socket outlet with a protective earthing connection.
• The lightning flash with the arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of un-insulated ‘dangerous voltage’ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
• The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance instructions in the service literature relevant to this appliance.

WEEE SYMBOL

• The crossed-out wheeled bin is the European Union symbol for indicating a separate collection of electrical and electronic equipment. This product contains electrical and electronic equipment which should be reused, recycled or recovered and should not be disposed of with unsorted regular waste. Please return the unit or contact the authorized dealer from whom you purchased this product for more information.
• This product conforms with Directive 2011/65/EU Restriction of Hazardous Substances in electrical and electronic equipment.

CE MARK

This product complies with European Low Voltage (2014/35/EU), Electromagnetic Compatibility (2014/30/EU), and Environmentally-friendly design of Energy- related Products (2009/125/EC) Directives when used and installed according to this instruction manual. For continued compliance only Cambridge Audio accessories should be used with this product and servicing must be referred to qualified service personnel.

UKCA MARK

• This product complies with UK Regulation Electrical Equipment (Safety) Regulations 2016, the Electromagnetic
• Compatibility Regulations 2016 and the Ecodesign for Energy-Related Products Regulations 2020 when used and installed according to this instruction manual.
• For continued compliance only Cambridge Audio accessories should be used with this product and servicing must be referred to qualified service personnel.

EC & UKCA DECLARATION OF CONFORMITY

• Hereby, Audio Partnership PLC declares that this product complies with Directive 2014/53/EU & UK Radio Equipment
• Regulations 2017, the full text of the CE & UKCA declaration of conformity is available at the following internet address: https://www.cambridgeaudio.com/DoC
• Bluetooth Radio Frequency:2.402GHz-2.48 GHz The Max. transmit power: 10dBm.
• Wi-Fi 2.4G Radio frequency: 2412-2472MHz, the Max. EIRP power 23dBm Wi-Fi 5G Radio frequency: 5150-5725MHz, the Max. EIRP power 26dBm

RCM (REGULATORY COMPLIANCE MARK)

• This product meets the Safety, EMC, and Radio Communications requirements of the ERAC and ACMA.

VENTILATION

• IMPORTANT – The unit will become hot when in use. Do not stack multiple units on top of each other. Do not place it in an enclosed area such as a bookcase or in a cabinet without sufficient ventilation.
• Ensure that small objects do not fall through any ventilation grille. If this happens, switch off immediately, disconnect from the mains supply, and contact your dealer for advice.
• Please ensure there is ample ventilation (at least 20cm clearance on the top, side, and rear). Do not put any objects on top of this unit. Do not situate it on a rug or other soft surface and do not obstruct any air inlets or outlet grilles.
• Do not cover the ventilation grilles with items such as newspapers, tablecloths, curtains, etc.

POSITIONING

• Choose the installation location carefully. Avoid placing it in direct sunlight or close to a source of heat. No naked flame sources, such as lighted candles, should be placed on the unit.
• Also avoid locations subject to vibration and excessive dust, cold, or moisture. The unit can be used in a moderate climate.
• This unit must be installed on a sturdy, level surface. Do not place it in a sealed area such as a bookcase or in a cabinet.
• Do not place the unit on an unstable surface or shelf. The unit may fall, causing serious injury to a child or adult as well as serious damage to the product.
• Do not place other equipment on top of the unit.
• Due to stray magnetic fields, turntables or CRT TVs should not be located nearby due to possible interference.
• Electronic audio components have a running for around a week (if used several hours per day). This will allow the new components to settle down and the sonic properties will improve over this time.

POWER SOURCES

• The unit should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company.
• This unit can be left in Standby mode when not in use and will draw <0.5W in this state. If you do not intend to use this unit for a long period, unplug it from the main socket.

OVERLOADING

• Do not overload wall outlets or extension cords as this can result in a risk of fire or electric shock. Overloaded AC outlets, extension cords, frayed power cords, damaged or cracked wire insulation, and broken plugs are dangerous.
• They may result in a shock or fire hazard.
• Be sure to insert each power cord securely. To prevent hum and noise, do not bundle the interconnect leads with the power cord or speaker leads.

CLEANING

• To clean the unit, wipe its case with a dry, lint-free cloth. Do not use any cleaning fluids containing alcohol, ammonia, or abrasives. Do not spray an aerosol at or near the unit.

BATTERY DISPOSAL

• Batteries may contain substances harmful to the environment. Please dispose of any discharged batteries with due consideration and by local environmental/electronic recycling guidelines.

SERVICING

• These units are not user-serviceable. Never attempt to repair, disassemble, or reconstruct the unit if there seems to be a problem.
• A serious electric shock could result if this precautionary measure is ignored. In the event of a problem or failure, please contact your dealer.

SUPPLIER’S DECLARATION OF CONFORMITY (DOC)

• Model(s): CA0930 Equipment: CXN100 Network Player
• Model(s): CA0940 Equipment: EXN100 Network Player
• Trademark: Cambridge Audio

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference,
2. this device must accept any interference received, including interference that may cause undesired operation.

The responsible party in the US:

• Company name: Audio Partnership LLC
• Address: 3057 N. Rockwell St. Bldg. 3, Fl. 2, Ste. 201. Chicago, IL 60618
• Phone: 312-636-3796

Legal Representative Person: Kiel Nowakowski

Signature: ————————–

FEDERAL COMMUNICATIONS COMMISSION NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

RF EXPOSURE STATEMENT:

To maintain compliance with FCC’s RF Exposure guidelines. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. Use only the supplied antenna.

MODIFICATIONS

The FCC requires the user to be notified that any changes or modifications to this device that are not expressly approved by
Cambridge Audio may void the user’s authority to operate the equipment.

CANADA-INDUSTRY CANADA (IC)

This radio transmitter has been approved by Industry Canada.
This Class B digital apparatus complies with Canadian standard ICES-003.
This device complies with Industry Canada License exempt RSS standard(s). Operation is subject to the following two conditions.

1. this device may not cause interference
2. this device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with RSS-102 limits set fourth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
The transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

• © 2023 Cambridge Audio Ltd.
• Cambridge Audio is a brand of Audio Partnership Plc.
• Registered office: Gallery Court, Hankey Place, London SE1 4BB.
• Reg. No. 2953313. All rights reserved.
• EU Importer: Cambridge Audio (EU) Limited. 1st Floor, 6 Lapp’s Quay, Cork, T12 VY7W, Ireland
• WWW.CAMBRIDGEAUDIO.COM
• AP38425/2

Documents / Resources

| CAMBRIDGE AUDIO CXN100 Safety Artwork [pdf] Instructions
CXN100, CXN100 Safety Artwork, Safety Artwork, Artwork
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>