ADAM elements 2ABY9SELFIE-PRO SELFIE-PRO Magnetic Tripod Selfie Stick User Manual

June 1, 2024
ADAM elements

ADAM elements 2ABY9SELFIE-PRO SELFIE-PRO Magnetic Tripod Selfie Stick User

Manual

ADAM elements 2ABY9SELFIE-PRO SELFIE-PRO Magnetic Tripod Selfie
Stick.JPG

www.dgosmtech.com

FIG 2.JPG

Product Introduction

FIG 3 Product Introduction.JPG

Release Tripod

Step 1:
Press the triangle button on the bottom of the tripod to release tripod legs.

Step 2:
Unfold the phone holder to be upright.

Step 3 :
Hold the handle sleeve with one hand and the pull handle of the phone holder with the other hand to pull out the telescopic rod. Adjust to desired height.
Tripod legs will open automatically as the telescopic rod being pulled out.

Fold Tripod

Hold the handle sleeve with one hand and push the telescopic rod back in.

Attention

  • Do not pull legs to open tripod.
  • Push the handle sleeve all the way down so that the tripod legs are fully opened and stable.

Detach/Attach Remote Controller & Charging

The remote controller of this product is detachable. Pull the center rod to leave space for sliding out the Bluetooth Remote Controller. Slide the Bluetooth Remote back in the slot to attach the remote with the tripod

When the battery is low, detach the remote controller and charge with the Micro USB included in the package.

FIG 6 Detach Attach Remote Controller & Charging.JPG

Connect Bluetooth

Long press the shutter/power button on the remote controller for 3 seconds until the green light flashes. On your device, go to Settings Bluetooth and turn on Bluetooth.
Find “SEAJIC” to connect. When pairing is completed, the green light will go off.

Short press the shutter/power button to take pictures when the connected smartphone is in camera mode.
Long press for 3 seconds again to turn off the Bluetooth.

Specifications

Tripod Parameters:

  • Boundary dimension: 60x49x243mm
  • Developed dimension: 1365mm
  • Weight: 275g
  • Material: ABS (fireproofi ng) PC (fi reproofing)
  • Bluetooth transmission distance: 10m
  • Battery capacity: 50mAh
  • Aluminum alloy

FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (l ) This device may not cause harmful interference, and (2) this device must accept any interference received, includmg Interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the usefs authority to operate the equipment

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful Interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful Interference to radio communications. However, there IS no guarantee that interference will not occur m a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the Interference by one or more of the following measures:

  • Reorient or relocate the receivmg antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals