Black Flag BZ-20 Series Bug Zappers User Manual
- June 1, 2024
- Black Flag
Table of Contents
Black Flag BZ-20 Series Bug Zappers User Manual
IMPORTANT SAFETY INSTRUCTIONS
Please read these instructions before using the Bug Zapper and keep it for future reference.
- This product is equipped with a 2-prong plug to fit the proper type of receptacles. To reduce the risk of electrical shock, only plug into a properly installed outlet.
- Do not insert fingers or any foreign objects into the unit while it is connected to an electrical outlet.
- Collected insects within the unit may contribute to fire so clean dead insects from the unit frequently.
- Do not clean this product with water spray or any other liquids. Do not place where it can fall into water, or near flammable materials.
- Store product indoors when not in use – out of reach of children.
- Always disconnect the plug before servicing, cleaning, and changing bulbs and when not in use.
- Do not abuse the cord – never carry the unit by cord or unplug the unit by pulling on the cord – only unplug by pulling on the plug. Keep the cord away from heat, oil, or sharp edges.
- Extension cords used with this product must be marked with suffix letters “W-A” and with a tag stating “Suitable for Use with Outdoor Appliances”.
- Use only extension cords that have plugs and receptacles that match the product plug. Replace damaged cords.
- The electrical rating of the extension cord must be as great as the electrical rating of the product.
- There are devices available for retaining a connection between an extension cord and a power supply cord. Connections should be kept off the ground and dry.
- Do not mount the unit on the house, other buildings, on decks or near heat, gas, oil or other flammable materials.
- For outdoor use only.
- Do not insert foreign objects into this product.
- Built with double insulated electronic components, When servicing, use only identical replacement parts. For household use only
WARNING
SKIN OR EYE DAMAGE MAY RESULT FROM DIRECTLY VIEWING THE LIGHT PRODUCED BY THE
LAMP IN THIS APPARATUS. ALWAYS DISCONNECT POWER BEFORE RELAMPING OR SERVICING.
IMPORTANT INFORMATION ABOUT INSECT CONTROL
The Bug Zapper is designed to lure and kill a wide range of flying insects.
The ultraviolet (UV) light given off by this unit is within the luminescent
range proven effective in attracting these insects. Insects are attracted to
the light and killed as they contact the electrically charged inner grid area.
Insects fall through the open base onto the ground. The outer grid helps
prevent pets, birds, butterflies, and children’s fingers from contacting the
charged grids. The unit is for outdoor use only and can withstand moderate
rain. For best results, the unit should be installed in early spring and left
on continuously throughout the season. Store in the garage, shed or basement
within the original box or similar size box to protect for next season.
CHOOSING A LOCATION (Figure 1)
When selecting a location, you want to remember the insects will be attracted to the unit so do not put the unit near human activity. Choose a location at least 20 feet away from the area you are trying to protect. If there is a water source nearby, place the unit between you and the water because water is often a breeding ground for flying insect pests.
INSTALLATION AND OPERATION
-
Unpack the unit, and save all packaging material for off-season storage.
-
Select the proper location to hang your unit using the information above choosing a location
-
Hang the unit approximately 5 – 7 feet above the ground from a tree, mounting pole or other free-standing object. Never mount the unit from the house or other building.
-
Plug the cord into a compatible extension cord rated for outdoor use.
-
The unit will be on once it is connected to an electrical source. This unit does not have an “on/off” switch. Please allow up to 3 minutes for the bulb to light completely.
-
This unit is designed to withstand moderate rain but should be taken down and stored indoors during severe weather.
-
It is recommended that this unit be put to use in early spring and left out until late fall to maximize effects.
-
Using the available lure will add to the effectiveness of the unit by attracting more insects to the unit.
-
Deluxe and MAX versions (BZ-40DX/MAX) have 2 settings-24 Hour Operation or Dusk to Dawn Sensor
Operation(Figure 2)- To select 24-Hour Operation, slide the yellow button on the cap down into the “24-Hrs” mode. The unit will remain on 24 hours a day.
- To select Dusk to Dawn Sensor Operation, slide the yellow button on the cap up into the “Half Moon” mode.
- The unit will turn on automatically at dusk, operate through the night and turn off in the morning.
INSTALLING THE BLACK FLAG MOSQUITO OCTENOL LURE (Figure 3)
You will find a Mosquito octanol lure included with the Bug Zapper Unit. Remove the lure clip from the pouch. Attach the clip to the outer grid of the zapper, any position on the zapper grid is good. Zapper effectiveness is increased by luring mosquitoes and biting flies to it. Replace the lure clip after every 30 days for best results. The universal fit mosquito octanol lure clip will fit on most Bug Zapper brands. To remove the clip simply push up the 2 prongs against the top of the grid and pull out.
CHANGING BULBS (Figures 4 & 5)
Use replacement bulbs. These bulbs should be replaced annually to maintain optimal UV effectiveness. Even though the bulb’s light may be visible to you, its ability to attract insects diminishes over time. If the bulb fails to light or the color of the light changes to yellow or orange it is time to replace the bulb.
- Unplug and remove the entire unit from the hanging position.
- Turn the unit upside down, open the bulb base by pushing the latch towards the centre of the unit lifting the base, and remove the old bulb.
- Insert the new bulb making sure it is properly seated in the socket.
- Close the bulb base by snapping it back into place. Place the unit back into the hanging position and plug it back into the outlet.
Note: If the unit fails to light after replacing the bulb, take the unit down remove the bulb and reseat 4 prongs of the bulb into the socket.
CLEANING
As the unit kills insects, most of the insect remains will be vaporized or fall through the unit. Some remains may be left on the grids and over time may reduce the effectiveness of this device. Make sure to regularly clean your unit to achieve maximum effectiveness. The time between each cleaning will vary depending on your insect population. Check your unit frequently and clean any insect remains you see.
- Unplug and remove the entire unit from the hanging position.
- Remove the bulb from the unit to avoid damage (see the above instructions).
- Using a small brush or stick, gently remove any insect remains from the outer casing and inner grids by inserting them into each horizontal grid slot and moving side to side.
- If available, you may use a portable hair dryer or compressed air to clean out your unit.
- Never use water to clean your unit, water could damage the electrical components.
- Be very careful not to move the grids from the seatings.
- Once the unit is clean, replace the bulbs, return the unit to the hanging position and reconnect to a power source.
Please use only the following lamp model by Cnlight Co. Ltd. for lamp replacement:
TROUBLESHOOTING
If the above troubleshooting does not solve the problem, please call consumer relations at 866-629-6652 or visit www.greenscapesinc.net
PRODUCT SPECIFICATIONS
PRODUCT LIMITED WARRANTY
Black Flag Model BZ-20 has a 1-year warranty, Model BZ-15N has a 3-year
warranty and other, larger models have a 5-year warranty against defective
material or workmanship from the date of purchase. Any defective part will be,
at the discretion of Greenscapes Home & Garden Inc., repaired or replaced at
no charge if the unit has not been tampered with and has been used according
to these printed instructions. The consumer is responsible for charges
incurred for shipping the defective unit to Greenscapes Home & Garden Inc. for
repair/replacement. Be sure to retain your purchase receipt to prove the
warranty. This warranty gives you specific legal rights as well as other
rights that vary from state to state.
ACCESSORIES
- Model # Description
- BB-15WHT – 15 Watt Replacement White bulb for BZ-15N and
- BZ-20 Zapper
- BB-40WHT – 40 Watt Replacement White bulb for BZ-40 Zapper
- BB- 40BLK – 40 Watt Replacement Black bulb for BZ-40-DX/MAX Zapper
- BZ-OCT1 – Mosquito Octenol Lure with Universal Fit Clip for Zappers
2017 All Rights Reserved
Greenscapes Home & Garden Inc, 200 Union Grove Rd SE, Calhoun, GA 30701. Phone
866-629-6652
www.greenscapesinc.net
EPA EST.NO. 08879-CHN-001 for Model Series BZ-40 and BZ-40DX/MAX
EPA EST. NO. 93178-CHN-1 for Model Series BZ-20 and BZ-15N Black Flag is a
trademark of United Industries Corporation and is used under license by
Greenscapes Home & Garden, Inc. Made in China.
Download PDF:Black Flag BZ-20 Series Bug Zappers User Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>