REMINGTON PG6030 All In One Grooming Kit Instruction Manual

: June 3, 2024
: Remington

Table of Contents

REMINGTON PG6030 All In One Grooming Kit
KEY FEATURES
GETTING STARTED
HOW TO USE
- Attaching and removing the trimmer attachments
CARE FOR YOUR GROOMER
IMPORTANT SAFETY INSTRUCTIONS
BATTERY REMOVAL
ENVIRONMENTAL PROTECTION
SERVICE AND GUARANTEE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

REMINGTON PG6030 All In One Grooming Kit

Thank you for buying your new Remington® product. Before use, please read these instructions carefully and keep them safe. Remove all packaging before use.

CAUTION

Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Remington®
Do not use this product if it is not working correctly, if it has been dropped or damaged, or dropped in water.

KEY FEATURES

REMINGTON-PG6030-All-In-One-Grooming-Kit-fig-1

On/off switch
Groomer
Wide trimmer
Detail trimmer
Miniscreen shaver
Nose, ear, eyebrow trimmer
2 attachment guide combs
Charging Indicator
Stand
Adaptor

3-year guarantee

GETTING STARTED

Charging your groomer

Before using your groomer for the first time, charge for 14-16 hours.
Make sure the product is turned off
Place your groomer into the stand, connect the adaptor to the product and then to the mains. The charging indicator will light up.

Your appliance cannot be overcharged. However if the product is not going to be used for an extended period of time (2-3 months), unplug it from the mains and store. Fully recharge your appliance when you would like to use it again.

To preserve battery life, let them run out every 6 months then recharge for 14-16 hours.

HOW TO USE

Attaching and removing guide combs

With the trimmer blade facing away from you, slide the guide comb over the back of the trimmer blade and click into position.
With the trimmer blade facing away from you, carefully push the guide comb away from the wide-head trimmer.

Before you begin

Comb facial hair with a fine comb before you start trimming. Hairs should be dry and without any waxes or lotions before using the groomer

To thin and taper beards or moustaches

Attach the wide trimmer blade.
Place the hair length attachment on the trimmer blade, select the desired length and switch on.
Start trimming under the chin, following the jawbone line. Work toward the ear and upper beard line using an upward motion.

To trim edge of beard or moustache

Attach the detail trimmer blade.
Hold groomer with cutting blade facing you.
Start with edge of beard/moustache line, and with the cutting blades resting lightly against your skin, use slow movements to create a beard/moustache line.

To trim sideburns

Hold groomer with cutting blade facing you.
Use a small comb to lift the hairs. Hold the comb at the desired beard or moustache length.
Move the groomer along the comb to cut the hairs. Use light pressure and well-controlled movements to trim hair.

Trimming the nape of your neck

Attach the wide trimmer blade.
Use your fingers to lift the hair at the base of your head up off the neck. Your index finger should be covering the roots of the hairs you are lifting to prevent accidental removal by a groomer.
Using your other hand, hold the groomer to the base of your neck with the cutting unit facing up, and move the groomer up the length of the neck until the unit touches your finger covering the hair roots at the base of your head.
Move the unit slowly when performing this operation and to keep the hair roots at the base of your head out of the way of the groomer.

To remove hair from nose and ear

Attach nose, ear & eyebrow attachment.
Insert groomer’s cutting unit gently into the nostril or ear.
Gently move the groomer in and out of the nostril or ear and at the same time rotate the groomer.
Avoid inserting the cutting unit more than 6mm into your nostril or ear.

To remove hair from eyebrows

Attach nose, ear, eyebrow attachment.
Gently guide cutting unit to stray, unwanted hairs along the eyebrow line or protruding from the eyebrow itself.
To remove the hairs completely lower onto the skin and move over desired area.
Use slow and well-controlled movements.

Tips for best results

Comb your hair in the direction that it grows so that the hairs are at their maximum height and facing in the same direction.
After trimming, lightly go over the trimmed areas with the foil to get a smooth clean finish.
Since all hairs do not grow in the same direction, you may want to try different trimming positions (i.e. upwards, downwards or across) for better results.

Attaching and removing the trimmer attachments

Note: Always ensure the groomer is switched off before changing any attachments.

To remove, hold the groomer with one hand and turn the trimmer head anti-clockwise with the other.
To attach, hold the groomer with on hand and turn the trimmer head clockwise with the other.

Using the detailed trimmer

Hold the groomer with the surface (back side) of the blade guiding against the skin.
Use motions similar to using a wet blade to provide the closest trim.

Note: This attachment provides a dual-purpose solution for stubble or close results without irritation.

Using your miniscreen shaver

Hold the groomer so the MiniScreen gently touches your face.
Use short, and well-controlled movements to shave around your beard/moustache. Use your free hand to stretch your skin. This encourages the hair to stand upright, making it easier to shave.

Note: The MiniScreen shaver was designed to shave the detail areas around your beard moustache/sideburns. It was not designed to shave your entire face. For a close comfortable shave, guaranteed, use one of Remington’s electric shavers.

CARE FOR YOUR GROOMER

Care for your product to ensure long-lasting performance. We recommend that you clean your groomer after each use. The easiest and the most hygienic way to clean the groomer is by rinsing the product head after use with warm water. Always keep the protective cap on the shaving head and keep the trimmer in the “off” position when the shaver is not in use.

After each use

Rinse the accumulated hair from the cutters and shake off excess water. Alternatively, use a brush.
Gently tap on a flat surface to remove hair particles, and brush the remaining hairs away.
Place one or two drops of cutter oil or sewing machine oil on the blades. Turn the clipper on to distribute the oil evenly, wipe off any excess oil.
Wipe the main unit with a damp cloth and dry it immediately.

Note: Ensure that the groomer is turned off when applying the oil or rinsing under the tap.

IMPORTANT SAFETY INSTRUCTIONS

Warning: To reduce the risks of burns, electrocution,fire or injury to persons:

An appliance should never be left unattended when plugged in to a power outlet, except when charging.
Keep the power plug and cord away from heated surfaces.
Make sure the power plug and cord do not get wet.
Do not plug or unplug the appliance with wet hands.
Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres.
Do not twist or kink the cable, and don’t wrap it around the appliance.
Store the product at a temperature between 15°C and 35°C.
Only use the parts supplied with the appliance.
The appliance, including its cord, must not be used, played with, cleaned or maintained by persons under eight years old and should at all times be kept out of their reach.
Use, cleaning or maintenance of the appliance by children over eight or by anyone with a lack of knowledge, experience or with reduced physical, sensory or mental capabilities should only be undertaken after receiving appropriate instruction and under the adequate supervision of a responsible adult to ensure that they do so safely and that the hazards involved are understood and avoided.
Always remember to turn on the groomer before you insert it into your nose or ear to avoid injury.
Don’t put the appliance in liquid, don’t use it near water in a bath-tub, basin or any other vessel, and don’t use it outdoors.

BATTERY REMOVAL

The battery must be removed from the appliance before it is scrapped.
The appliance must be disconnected from the supply mains when removing the battery.
Unplug groomer from the outlet to avoid risk of electrical shock.
Pry the upper housing from the product with a flat head screwdriver. This will expose the batteries.
With wire cutters, clip the wires leading to the batteries.
Remove the batteries from the product. Contact your local authorities for proper disposal.
The battery is to be disposed of safely.

ENVIRONMENTAL PROTECTION

To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol must not be of with unsorted municipal waste, but recovered, reused or recycled.

SERVICE AND GUARANTEE

This product has been checked and is free of defects. We guarantee this product against any defects that are due to faulty material or workmanship for the guarantee period from the original date of consumer purchase. If the product should become defective within the guarantee period, we will repair any such defect or elect to replace the product or any part of it without charge, provided there is proof of purchase. This does not mean an extension of the guarantee period. In the case of a guarantee simply call the Service Centre in your region. This guarantee is offered over and above your normal statutory rights. The guarantee shall apply in all countries in which our product was sold via an authorised dealer. This guarantee does not include damage to the product by accident or misuse, abuse, alteration to the product or use inconsistent with the technical and/or safety instructions required. This guarantee shall not apply if the product has been dismantled or repaired by a person not authorised by us. If you call the Service Centre, please have the Model No. to hand, as we won’t be able to help you without it. Its on the rating plate which can be found on the appliance.

Remington® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries