ECOFLOW 28 Inch Tilt Mount Bracket User Manual

ECOFLOW 28 Inch Tilt Mount Bracket

Disclaimer

Please read this User Manual and ensure you understand it fully before using the product. Please keep this User Manual properly for future reference. Any incorrect usage may result in severe injury to the user or others, damage to the product, or loss of property. By using this product, the user will be deemed as having understood, recognized, and accepted all the terms and contents of the User Manual, and will be responsible for any incorrect usage and all consequences arising therefrom. EcoFlow hereby disclaims any liability for any losses due to the user’s failure to use the product in accordance with the User Manual. In compliance with laws and regulations, EcoFlow shall have the final right to interpret this document and all related documents for this product. Any update, revision, or termination of the contents thereof, if necessary, shall be made without prior notice, and users may visit the official website of EcoFlow for the latest information on the product.

Safety Instructions

1. This product is applicable to EcoFlow rigid solar panel series with the following models： 100 W Rigid Solar Panel(EF-SG-M100).
2. Place the solar panel on a soft material to avoid friction with the ground during installation.
3. Be sure to wear protective gloves and safety goggles during installation to avoid being scratched.
4. When installing the bracket, be sure to use the mounting holes reserved for the solar panel, and do not drill or modify the module frame without authorization, which will void the warranty.
5. Check the connections of parts every three months to ensure that they are intact.
6. Do not use non-official accessories. If you need to replace components or accessories, purchase them from EcoFlow’s official sales channels.

Packing List

1. Hex bolt

2. Spring washer

3. Flat washer

4. Flange nut

5. Torx screw

6. Wing nut

7. Self-drilling screw

8. Plastic retaining ring

9. Fixing bracket

10. Adjustable bracket

• Be sure to wear protective gloves and safety goggles during installation to avoid being scratched.
• The tools required for installation are not included in the list, please purchase them yourself.

Usage

This system can flexibly tune the elevation angle by adjusting the installation buckle to keep the solar panel at a vertical angle to the sun’s rays, which ensures optimal power production. For information about the best elevation angle for a solar system, please refer to your local solar system installation guide or the solar manufacturer’s installation requirements.

• Please fix the solar panel bracket on a flat surface when the elevation angle is greater than 60°.

Installation Steps

Installation on the short side

1. Install the two fixing brackets on the back of the solar panel
   • Flange nut
   • Flat washer
   • Spring washer
   • Hex bolt
   • Fixing bracket
2. Connect the other two fixing brackets
   • Torx screw
   • Wing nut (interior)
   • Fixing bracket
3. Adjust to an appropriate elevation angle and install the adjustable bracket
   • After the installation is completed, flip the solar panel over to use it instantly.

Installation on the long side
The installation is identical to Installation on the short side, please refer to the figures below for reference.

Fixed installation
For permanent fixed use, please fix the bracket on a flat surface before Step 3 -Long Side / Short Side Installation. For installation steps, refer to the figure below:

• Drilled area*
• Self-drilling screw
• Plastic retaining ring
• Glued area(grey)

After drilling holes in the pre-installation position, first glue waterproof silicone around the holes, and then secure them with self-drilling screws.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>