75F MT 2AVZO-MT 8 Inch CM with Internal Antenna – XR User Manual
- June 1, 2024
- 75F
Table of Contents
- 75F MT 2AVZO-MT 8 Inch CM with Internal Antenna – XR
- Copyright © ….
- 1. Introduction
- 2. Exploring Your Device
- 3. Device Layout
- Bottom View
- 4. Managing Device Power
- 5. Using the 8″ CM with Internal Antenna – XR
- 6. Precautions for the safe use of the product.
- 7. Troubleshooting
- FCC Statement
- Part 15B Equipment
- FCC RF Radiation Exposure and SAR Statements
- Specifications:
- FAQ:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
75F MT 2AVZO-MT 8 Inch CM with Internal Antenna – XR
USER MANUAL
Copyright © ….
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or
transmitted in any form, by any means (electronic, photocopying, recording, or
otherwise) without the prior written permission of the publisher.
Copyright protection claimed includes all forms and matters of copyrightable
material and information allowed by statutory or judicial law or hereafter
granted, including without limitation, material generated from the software
programs which are displayed on the screen such as screen displays, menus,
etc.
Products that are referred to in this document may be either trademarks and/or
registered trademarks of the respective owners. The publisher and the author
do not claim these trademarks.
While every precaution has been taken in the preparation of this document, the
publisher and the author assume no responsibility for errors or omissions, or
for damages resulting from the use of the information contained in this
document or from the use of programs and source code that may accompany it. In
no event shall the publisher and the author be liable for any loss of profit
or any other commercial damage caused or alleged to have been caused directly
or indirectly by this document.
Content subject to change without notice.
1. Introduction
Welcome to your 8″ CM with Internal Antenna – XR.
To ensure the optimal performance of this product, please take the time to
read this manual carefully.
Explanation of Advisements
In this manual we use three (3) levels of Advisements as follows:
- The Note symbol is used for notifying the user of something important or of something that needs special attention.
- The Caution symbol is used to inform of something that could cause harm to or malfunction of the e equipment.
- The Warning symbolis used to informof something in which there is a conceivable risk of harm to the user if the Warning is ignored.
Symbols and Markings
This section provides information about the symbols that are used on the 8″ CM with Internal Antenna – XR, it is accessories or packaging.
FCC: This is a certification mark employed on electronic products manufactured or sold in the United States which certifiesthattheelectromagneticinterferencefromthedeviceisunder limitsapprovedbytheFederalCommunications Commission.
2. Exploring Your Device
Package Contents
In addition to the primary tablet unit, your product carton should contain all the below items.
3. Device Layout
Item | Component | Description |
---|---|---|
1 | Analog Inputs | 6x input(4 resistance and 2 voltage) |
2 | RS485 | TX/RX |
3 | Sensor Bus | Temperature sensor |
4 | Control Mote | RF module |
5 | USB Dongle | D+,D-,VCC,GND |
6 | AC/DC Input | AC/DC 24V |
7 | Relay Outputs | 5x 24v output |
8 | Relay Outputs | 2x 24v output |
9 | Analog Outputs | 4x output( 0~10v) |
10 | RJ45 | 10/100Mbps only |
Bottom View
Item | Component | Description |
---|---|---|
11 | Label location | FCC |
4. Managing Device Power
Adapter
24V DC / 24Vrms AC power supply
Batteries
NO
5. Using the 8″ CM with Internal Antenna – XR
Inserting the AC/DC 24V to the power port(#6) will automatically power on .
6. Precautions for the safe use of the product.
Before using the 8″ CM with Internal Antenna – XR device, please read this manual and precautions carefully. Otherwise some unforeseen consequences can occur. The operating environment temperature of the equipment should not exceed 50℃
7. Troubleshooting
In most cases, restarting your device will cure any problem. If your device
has crashed,please reset the unit .
If this does not fix the problem, contact your supplier.
Please have your serial number ready. This can be found on the back of your
device.
Appendix A Compliance Information
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
Modifications not expressly approved by Device Manufacturer could void the user’s authority to operate the equipment under FCC rules.
Part 15B Equipment
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment .
FCC RF Radiation Exposure and SAR Statements
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Specifications:
-
Model: 8 CM with Internal Antenna – XR
-
Version: 1.0
-
Date: 10/2023
-
-
FAQ:
Q: What should I do if the device does not power on after inserting the
AC/DC 24V?
A: Check the power source and ensure it meets the required specifications. If the issue persists, contact customer support.
Q: Can I use batteries to power the device?
A: No, the device is powered using a 24V DC / 24Vrms AC power supply.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>