COMPASS MANUFACTURING INTERNATIONAL 182-6590 Polished Chrome Instruction Manual
- June 3, 2024
- COMPASS MANUFACTURING INTERNATIONAL
Table of Contents
Model No. : 182-6590 Polished Chrome
182-6591 Brushed Nickel
182-6592 Oil-Rubbed Bronze
182-7511 Matte Black
Aegean Towel Ring
Parts Diagram / List
Tools
- Level
- Power Drill
- 1/4” Drill Bit
- 1/16” Drill Bit
- Masking Tape
- Pencil
- Hammer
- Phillips Screw Driver
- Safety Glasses
- Stud Finder
Maintenance
Your new Bath Accessory is designed for years of trouble-free performance.
Keep it looking new by cleaning it periodically with a soft cloth. Avoid
abrasive cleaners, steel wool and harsh chemicals as these will dull the
finish and void your warranty.
| No. | Part Name |
|---|---|
| 1 | Base |
| 2 | Set Screw |
| 3 | Trim Cap |
| 4 | Towel Ring |
| 5 | Allen Screw |
| 6 | Wearing Ring |
| 7 | Allen Wrench |
| 8 | Mounting Bracket |
| 9 | Insert Anchors |
| 10 | Mounting Screws |
| 11 | Template |
Installation Instructions
Step 1
Locate mounting hardware before throwing away any packaging.
Step 2
Use the stud finder to locate the studs. Determine which mounting step is best
for the installation. Place the template (#11) on the wall in the desired
location, verify it is level, and tape it to the wall.
Step 3
Mark the mounting screw holes through the template (#11) with the pencil, then
remove the template (#11).
Drywall Installation
Step 4
Drywall or Ceramic Tile Installation:
Drill 1/4″ holes in the wall where marked, then push the insert anchors (#9)
into the holes, using the hammer to gently tap them into place.
Wood Wall Stud Installation
Wood Wall Stud
Installation:
Drill 1 /16″ holes in the wall were marked, keeping the drill level. Insert
anchors (#9) will NOT be used.
Step 5
Dry Wall Installation: –
Hold the mounting bracket (#8) over the mounting holes and tighten the
mounting screws (#10) into the insert anchors (#9). See Figure 1 for an
example.
Wood Wall Stud Installation:
Hold the mounting bracket (#8) over the mounting holes and tighten the
mounting screws (#10) directly into the pre-drilled holes. See Figure 2 for an
example.
Step 6
Position the base (#1) over the mounting bracket (#8) with the set screw
socket facing down. Tighten the set screw (#2), using the provided Allen
wrench (#7).
LIMITED LIFETIME WARRANTY
Compass Manufacturing International warrants to the original consumer
purchaser that the faucet be free from defects in material and workmanship for
as long as the original consumer purchaser owns the home in which the faucet
was first installed.
In the event that Freendo bathroom accessories are used in a Commercial
Application, this warranty is limited for a period of 5 years, unless
otherwise specifically stated in the catalog and/or price book.
Compass Manufacturing International will replace, free of charge, during the
applicable warranty period, any part or finish that proves defective in
material and/or workmanship under normal installation, use, and service. This
warranty shall not apply to goods that have been subject to accidents,
negligence, or improper installation. Compass Manufacturing International will
not be liable for other damages or losses, including, but not limited to:
labor charges and/or damages incurred in installation, repair or replacement
as well as any other kind of loss or damage. Proof of purchase from the
original consumer purchaser must be made available for all warranty claims.
Compass Manufacturing International recommends using a professional plumber
for all installation and repair. Compass Manufacturing International will, at
its discretion, provide new or equivalent replacement parts for any product
that proves to be defective under normal usage and service. Replacement parts
may be obtained by emailing the address below, calling the number below or by
writing to:
Compass Manufacturing International
Friends Product Service
6702 Enterprise Drive
Louisville, K¥ 40214
800.626.3525
warranty@cmiproduct.com
warranty@cmiproduct.com
Revised 05/05/21
© Compass Manufacturing International 800.626.3525
Template Front View
Position Bracket and Drill Holes as Indicated
Towel Ring
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>