JC-LGL 240W UFO High Bay Instruction Manual

JC-LGL 240W UFO High Bay

Thank you for purchasing our UFO Highbay. Please read the below articles carefully to see how to use this product safely.
Warning contents and attention contents related to product safety use, please be sure to follow it.

WARNING

• Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this product must be performed by a qualified electrician.
• This product must be installed by the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
• Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting any maintenance. Disconnect power at the fuse or circuit breaker.
• Risk of Fire- Minimum 90°C supply conductors.
• Risk of Burn- Disconnect power and allow the fixture to cool before handling or servicing.
• Risk of Personal Injury- Due to sharp edges, handle with care.
• Failure to comply with these instructions may result in death, serious bodily injury and property damage.

Attention

1. This UFO High Bay is within the input voltage range: of 120V, 60Hz.
2. If the input voltage exceeds this range, it may cause the lamp to fail. Please be sure to operate under the correct input voltage
3. If the input voltage exceeds this range, it may cause the lamp to fail. Please be sure to operate under the correct input voltage:
4. Ensure the ambient operating temperature of -35 C ~50 €.
5. Using this UFO high bay in temperatures outside of this range will reduce the UFO high bay lifespan:
6. Make sure to turn off the power before starting the installation process.
7. The IP rating of IP65 can work under damp/wet locations.
8. Please keep the UFO High Bay away from any corrosive substance.
9. When you clean it, please use a damp or dry cloth.

Wiring Diagram

Product Dimension

Installation

1. Take out the hook from the accessory bag, and screw the hook into the 3/4 hole of the fixture to lock it.
   Note: While assembling the hook, don’t rotate the power cord with the hook to avoid twisting the power cord.

2. After the hook is locked in place, there is an M4x8 screw on the hook base, please screw it tighten to ensure the hook will not rotate and fall off easily.

3. Hanging the fixture in the fixed position

4. Lock the M4X30 screw to ensure the fixture does not fall when it shakes.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>