DS18 SB26BTXRGB Motorcycle Speaker Owner’s Manual

DS18 SB26BTXRGB Motorcycle Speaker

FOR MORE INFORMATION PLEASE VISIT DS18.COM

OWNER’S MANUAL

AMPLIFIED SOUNDBAR WITH BLUETOOTH / USB & RGB LIGHTHING

KNOWING YOUR SB26BTXRGB

1. Main Power Wire
   Cable de Powder Principal

2. 3.5mm Aux-Input
   Entrada Au xi liar de 3.5mm

3. USB Jack
   Puerto USB

4. Control Panel
   Panel de Control

PACKAGING INCLUDES

• 1 x SB26BTXRGB Soundbar
• 1 x Remote Control
• 2x Tube clamp adjustable 1.5″ to
• 2.25″ diameter
• 4x NBR pad
• 1 set of screws and stop washers
• NOTE: The stainless steel hardware supplied with your soundbar has been chosen to resist rust and corrosion. If the particular hardware supplied will not work for your install1ation purposes, please be sure to use only appropriate marine grade (stainless steel) mounting hardware

BLUETOOTH OPERATION

PAIRING & DISCOVERING A NEW BLUETOOTH CONNECTION

1. Long Press the Power Button 5 until the Soundbar Turns On

2. The SB26BTXRGB will automatically go into pairing mode:
   ANDROID AND 105 USERS:

   • A. Go into settings menu of your device
   • B. Enter the Bluetooth Menu
   • C. Turn On Bluetooth and press SCAN
   • D. “SB26BTXRGB” Will now be displayed under AVAILABLE DEVICES
   • E. If Prompted, enter pass code: “0000

3. If SB26BTXRGB is not seen, repeat the above steps to “refresh” the “device list”

4. When the connection is successful, you are now ready to stream music from your favorite media player to the SB26BTXRGB

BLUETOOTH STREAMING

MULTIFUNCTION CONTROLLER BLUETOOTH OPERATION

1. Use this PLAY /PAUSE button 8 to Play or Pause the music from your device.
2. Use this NEXT11 Button to select the next track or song on your playlist.
3. Use this PREVIOUS 6 Button once to  restart the song that Is playing, or press again to go back to the previous song In your  play list

VOLUME CONTROL

1. press the VOL+ 10 Button to raise the volume or you can also use the volume control on your connected device.
2. To lower the volume press (6 the VOLUME OOWN button or use your devices controls

TIPS
For maximum audio performance, depending of your type of music, you can change the EQ presets from your remote control to avoid distortion at hi-level of volume

AUX INPUT

AUX-IN OPERATION

1. Long Press the Power Button 5 until the Soundbar Turns On
2. Use a 3.5mm Jack cable device and connect it to the AUX-IN  2 jack connector located behind the rubber cover  one side of the soundbar.
3. The AUX Mode is activated once the jack connector is in. Now you can adjust the volume for your preference and play audio from your device

TIPS
It is recommended to set the volume at 75’1. for the least amount of distortion from your device and to only use the soundbar to control your master volume

USB PLAYER

USB CONTROLS OPERATION

1. Long Press the Power Button 5 until the Soundbar Turns On
2.  Insert an USB Flash Drive on the USB Port 3 that is located behind the rubber cover at one side of the soundbar, once inserted the audio files start playing automatically
3. Press PLAY /PAUSE button 8 to Play or Pause the Audio Files from your USB.
4. Use this NEXT 11 Button to select the next track or song on your USB playlist.
5. Use this PREVIOUS 6 Button once to restart the song that is playing, or press again to go ba.ck to the previous song in your USB playlist

TIPS
The USB Player only Accepts MP3 and WMA Formats, also can be use as a 1 amp charger Port

REMOTECONTROL

REMOTE CONTROL OPERATION

1. Make sure the battery Is Installed and the protector has been removed
2. The remote control needs to be pointed to the RF sensor@ In the Soundbar to operate.
3. Press the desired function on the remote control: Power ON/OFF (1), Mode (2), EQ presets (3), Next (4), Vol- (5), Play/Pause (6), Vol+ (7), Previous (8), Folder down (9), Folder up (10 )

INSTALLATION

READ BEFORE INSTALLATION

1. Be sure to carefully read and understand the instructions before attempting to install this soundbar.
2. For safety, disconnect the negative battery terminal from the battery prior to beginning the installation
3. For easier assembly, we suggest you have ail your tools in hand- Drill, Allen set, Crimp, Soldering iron, Wire Strippers, Heat-shrink. etc,
4. Use high quality “Waterproof’ connectors for a reliable installation and to minimize signal or power loss.
5. Think before vou drill! Be careful not to cut or drill into gas tank, fuel lines, brake or hydraulic lines, vacuum lines or electrical wiring when working on any vehicle.
6. Never run wares near fuel lines or power (if possible). Running the wires inside the hull or car area provides the best protection.
7. Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect any wires routed through metal, especially on the Roll Cage.  B. Make sure that the mounting clamp is tight before leaving the Vehicle

BEGINNING MOUNTING

• Step 1: Remove the soundbar and hardware from the packaging.
• Step 2: Find a GOOD location that allows for easy wiring of the Soundbar (Power Welt)-PLUS does NOT Impair your movement around the location.
• Step 3: Using 5mm Allen l<ey spin out the screw that holds the top clamp (if was mounted)
• Step 4: Take the base clamp ID) and align it to the Product installation hole and secure it with the short screw (C) using a 5mm Allen key.
• Step 5: Wrap the rubber pad around the pipe and lock t he top clamp (B),
• Step 6: Align the Clamp (B) with the base clamp (D) and use the supplied screws (A) to tighten down the clamps using a 5mm Allen Key.
• Step 7: Do the same procedure on each clamp supplied, you may need an extra help from somebody to hold up the Soundbar during the

Clamp Installation.

• Step B: Once you tighten all screws. run the Power wire to the battery location, use zip ties to secure the cable away from elements that can damage.
• Tills is lt1!
• Enjoy your new SB26BTXRGB Soundbar

IMPORTANT
For water resistance purposes remove and US8 0< Auxiliary cables and be sure to put the rubber caps or= In place benne using this soundbar in wet locations or when washing your vehicle

CAUTION
Using other mounting methods may void this warranty

WIRING INSTALLATION

SPECIFICATIONS

• SPECIFICATIONS/ ESPECIFICACIONES
• Nominal Size  26″ / 660mm
• Total Watts (Peak) 600 Watts
• RMS Power@4 ohm  100 Watts
• Lax Power @4 ohm. 200Watts
• Frequency Response   45Hz·20KHz
• Storage Temperature  176° 1′
• Operation Temperature 32°F – 140°F (0°C – 60°C)
• Operation Voltage  12 Volts (10-16 Volts Range)

BODY /FEATURES/

• Marine Grade Type . lPX5

• Body Material  Aluminum

• Grill Type Steel Mesh

• Qty on Box   1 piece

• Clamps  2 Set (Tube Clamp Adjustable 1.5″ – 2.25″)

• Front Logo  Ye Aux line Input Yes, (720mV) / Si. l720mV)
  EQ I DSP 5 Preset EQ (for Bluetooth and USB Mode

• USB Player Yes (WMA, MP3 files)/ Si (Archives MP3, WMA)

• USB Charge Yes (1 Amp)/ Sil1 Amp)

• Buttons(Power. Mode. Play/Pause.Fwd, Vol+/Vol-)

• Remote ControYes IRF Card Type)

• illumination Yes (Blue Backlit) + RGB LED Adjustable Si

WOOFER SPECIFICATIONS

• Nominal Diameter. 3″ I 76.2mm (4 Pcs)
• Voice Coil Diameter 120.4mm
• Voice Coil Former Material Kapton
• Cone Material   Paper
• Surround Material Cloth
• Basket Material   Steel
• Magnet Material  Ferrite
• Motor Diameter2.36″ / 60mm

TWEETER SPECIFICATIONS

• Nominal Diameter  0.94″ I 24mm (2 Pcs)
• Voice Coil Diameter 0.8″ 120.4mm
• Type   Dome
• Diaphragm Material  Soft Dome
• Magnet Material
• Crossover 6dB

SPECIFICATIONS

AMPLIFIER SPECIFICATIONS

• Amplifier Class Class A/B
• Amplifier Type  Stereo Full Range
• Number of Channels  4
• Minimum Impedance  3 ohm
• Signal to Noise Ratio  6BdB
• T.H.D.  1’1. @1000Hz
• Channel Separation  60dB
• Audio Source Bluetooth. USB. AUX.
• Power Input Wire Sir x16ga
• Recommend Fuse Size 10A
• MAX Current Draw  7A
• Thermal Protection  Yes I Si (>284 °F )
• Over-Load Protection  Yes / SI
• Short Circuit Output Protection Yes

BLUETOOTH SPECIFICATIONS

• Version VS
• Audio Protocols A2DP
• Range >33ft (10ml’ / Class 2

MEASUREMENT

• Overall Width 26″ / 660 mm
• Overall Height.98″ / 101 mm
• Overall Depth 3.98″ / 101 mm

DIMENSIONS

TROUBLESHOOTING

WARRANTY

Please visit our website 0S18.com for more Information on our warranty  policy.

WARNING:
Cancer and Reproductive Harm. www.P65Warning.ca.gov

FCC Warning This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful! interference, and
2. This device must accept any interference received,  including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party- responsible for compliance could void the user’s authority to operate the  equipment.

NOTE: This equipment has been tested and found to comply with the limits! for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful- interference in a residential installation. This equipment generates, uses and! can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio! communications. However, there is no guarantee that interference will not. occur in a particular installation

• If this equipment does cause harmful interference to radio or television! reception,  which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different- from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an + uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body P

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>