EUCHIPS Walldim103E1 Dim Switch User Guide
- June 1, 2024
- EUCHIPS
Table of Contents
EUCHIPS Walldim103E1 Dim Switch
Product Information
Specifications
- Model: Walldim103E1
- Output Control: Variable resistance signal
- Control Output Load Capacity: Max. 20 mA
- Switching Output Load Capacity: Max. 6 A resistive load
- Type: Passive dimmer
- Panel Color: Ivory-white
- Panel Size: 868642mm (WHD)
- Packing Size: 10410452mm (WHD)
- Weight: 140g
- Working Temperature: -10~55°C
- Relative Humidity: 20-90% RH
FAQ
- Q: Can I use this dimmer for LED lights?
- A: This dimmer is designed for resistive loads. It is recommended to check with the manufacturer if it is compatible with LED lights or use a specific LED-compatible dimmer.
- Q: What is the working temperature range of Walldim103E1?
- A: The working temperature range is between -10°C to 55°C.
Product Features
- Suitable for 1-10V LED dimming driver with passive signal support
- Installation in the European and domestic electrical box
- Can switch off the signal and power supply at the same time
- ABS material, high flame retardant
- Fashion, and easy to use
- Used in the study, bedroom, restaurant, bars and other places need dimming control
Technical Parameters
| Model | Walldim103E1 |
|---|---|
| Output | Variable resistance signal |
| Control output load capacity | Max. 20 mA |
| Switching output load capacity | Max. 6 A resistive load |
| Type | Passive dimmer |
| Panel color | Ivory-white |
| Panel size | 868642mm(WHD) |
| Packing size | 10410452mm(WHD) |
| G.W. | 140g℃ |
| Working temp. | -10~55 |
| Relative humidity | 20-90% RH |
Function Description
- Turn the knob clockwise , after hear the ‘click’ sound，the knob signal is turned on ,continue to adjust the knob ,the brightness of light varies from minimum to maximum. Turn the knob by counterclockwise, the brightness of light varies from maximum to minimum ,continue to adjust the knob，after hear the ‘click’ sound, the knob signal is closed.
Wiring And Dimension Diagram
Wiring Diagram
Dimension(mm)
Installation Guide
- Mount an electrical box inside the wall
- To separate the panel and the back cover of the controller with a screwdriver along the gap of the back cover.
- Connect the wires according to the “Wiring Diagram”
- To put the back cover on the electrical box and fix it with the screw.
- To buckle the glass panel to the bottom box.
Caution
- Connect the load wire at first, then connect the power wire; Please ensure a short circuit can not occur between wires before you turn on the power.
- Please check the input voltage and frequency range, it may burn out the dimmer once exceeds the voltage or frequency range.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>