JOYTUTUS V01-230831 2018 2023 Wrangler JL Mounting Brackets Installation Guide
- June 1, 2024
- JOYTUTUS
Table of Contents
USAGE GUIDELINES
SKU: A2701-17601
V01-230831 2018 2023 Wrangler JL Mounting Brackets
IMPORTANT
Before installation, please make sure that all accessories are ready.
(As shown in the picture below).
Estimated installation time: 60 minutes
Required tools :
(to be prepared by oneself)
PRODUCT INFORMATION
SPARE PRODUCT INFORMATION
INSTALLATION METHOD
STEP 1: Use [17] to assemble [1] and [2].
STEP 2: Use [18] to assemble [4] and
[2].
STEP 3: Use [17] to assemble [3] and
[2].
STEP 4: Use [13][14][15][16] to
install the assembled [1] in the engine compartment as shown in the figure.
STEP 5: Installation is complete.
WIRING STEPS
STEP 1: Remove the lid of [3] and take out the original fuse box cover.
STEP 2: Take out the original fuse from the original fuse box (Find
thelocation of F57 on the back of the original fuse box cover.)
NOTE: F57 or other suitable original insurance films can be selected
according to actual needs.
STEP 3: Insert the original fuse into [6] as shown in the diagram,
connect [6] and [11], and clamp the joint with pliers.
STEP 4: Insert [6] into the hole located at F57 and insert [11] into the
indicated position of [3] as shown in the diagram.
STEP 5: Cover the original fuse box with its cover, making sure that [11]
passes through the designated position (to avoid pressing on the wire
harness).
STEP 6: The connection points for [8], [9], and [10] are indicated by
[A], [B], and [C] respectively ([8] connects to [A], [9] connects to [B], and
[10] connects to [C]).
STEP 7 : Connect [8] to [A], [9] to [B], and [10] to [C].
STEP 8: Loosen and separate the wire harness connection point for [5].
STEP 9: Remove the two covers on the driver’s side as shown in the
diagram.
STEP 10: Thread the hole above the wire harness for [5] through the top
hole and out the bottom hole as shown in the diagram.
STEP 11: Connect and tighten the wire harness connection point for [5],
and thread the wire harness out from under the driver’s side (through the
indicated hole in the diagram).
NOTE: It may be necessary to break the inner silicone to thread the wire
harness through.
STEP 12: Thread the wire harness for [5] out from the engine compartment
and secure it to [D] using [12].
STEP 13 : Insert the wire harness for [5] into the designated position on
[3] as shown in the diagram.
STEP 14: Pull all the wire harnesses on [3] to the outlet on the cover of
[3], and then close the cover.
STEP 15: Press the button on [4] to power on.
STEP 16: Wiring is complete.
BRACKET INSTALLATION OF SWITCH BUTTON
If you have any questions, please visit Joytutus website or email for quick
response.
Web: www.joytutus.com
Email: Service@joytutus.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>