KINGYES A111-010-001 HDPE Double Table Instruction Manual
- June 1, 2024
- KINGYES
Table of Contents
KINGYES A111-010-001 HDPE Double Table
Important – Please read these instructions fully before starting assembly
HASSLE-FREE WARRANTY
Kingyes stand behind the quality of our products. For a full warranty policy,
email: info@kingyesoutdoor.com
Safety & Care Advice
Important – Please read these instructions fully before starting assembly.
- Check you have all the components and tools listed on.
- Remove all fittings from the plastic bags and separate them into their groups.
- Keep children and animals away from the work area, small parts may cause choking if swallowed.
- Make sure you have enough space to layout the parts before starting.
- Assemble on a soft level surface to avoid damaging the unit or your floor.
- Do not stand or put weight on the product, this could cause damage.
- Assemble the item as close to its final position (in the same area) as possible.
- Do not place furniture directly in front of radiators, fires or any other source of heat.
General care & maintenance
- Using damp cloth and mild detergent for routine maintenance, do not use blench or abrasive cleaners.
- From time to time check that there are no loose screws on this unit.
Clean & Sanitize Tips
Use this method for a quick clean-up here and there throughout the season –
adding in the bleach solution to easily sanitize and eliminate any stubborn
stains or dirt build-up from the winter months.
- Mix mild dish soap and warm water in a bucket.
- Use a clean cloth to wipe the soapy mixture onto the surfaces of your furniture, cleaning off any dirt.
- For extra cleaning power or to sanitize, mix 1/3 bleach and 2/3 water.
- Apply bleach mixture to furniture with a clean cloth and allow it to sit on the lumber for a few minutes (this will not affect the color).
- Loosen any dirt and debris that may catch in the surface grooves of the lumber by scrubbing the bleach mixture with a soft-bristle brush.
- Rinse thoroughly using a garden hose with a spray nozzle.
Components
Please check you have all the components listed below.
Note: The illustration of the chair shows the exact position of each
part. Check when assembling.
Hardware & Tools
May: Thupuind than regiare the corect amount to complete the assembly. In
some cases more fittings.
Note: The quantities below are the correct amount to complete the assembly. In some cases, more fittings may be supplied than required.
Assembly Instructions
Caution: Please do not over-tighten bolts and screws during assembly.
-
STEP 1
Attach “Stretcher (C)” to “Leg (B)”, you get 2 pieces of “Side Frame” – Using “D M6 × 60MM Screw”, tighten with hex key. -
STEP 2
Attach “Open Shelf (D)” to the “Side Frame” you get from step 1 – Using “D M6 -
60MM Screw”, tighten with hex key.
-
STEP 3
Attach “Leg (B)” to “Table Top (A)” – Using “D M6 × 60MM Screw”, tighten with hex key.
If you need help or have damaged or missing parts. please email: info@kingyesoutdoor.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>