FLUXLAMP Solar Lamp 600LM User Manual
- June 1, 2024
- FLUXLAMP
Table of Contents
Solar Lamp 600LM
User Manual
Product Specifications:
- Light Source: 1x LED filament
- Brightness: 600LM
- Charging Interface: Solar panel
- Output: 5.5V 1W
- Capacity: 1800mAh
- Functions: 3 lighting modes
- Lighting Duration: 8 hours (at full charge)
- Sensing Distance: 5-8m
- Sensing Angle: 120°
- Product Weight: 188.5g
Basic Safety Precautions:
- During initial use, place the lamp in an area with ample sunlight for charging. Allow the product to charge for several hours before use.
- If the lamp will not be used for an extended period, position it in a sunny area for at least one day of charging. For optimal battery function, it’s recommended to fully charge the lamp in a well-lit area once a month.
- The charging time and efficiency of the solar panel may vary depending on weather conditions and installation position. Consider the solar power generation conversion rate; optimal charging efficiency is achieved in favorable weather conditions.
- If sunlight or other light sources are present and the power switch is off, the LED lamp will not illuminate during the day or night.
- Install the solar lamp in a location with sufficient light to ensure the solar panel absorbs sunlight adequately, extending the lamp’s working hours.
- Adjust the angle and direction of the lamp to the optimal position, ideally 2-3m in height.
- During winter or periods of limited sunlight, it’s recommended to use mode 1.
Method of Use:
- Place the lamp in direct sunlight to charge the built-in battery.
- Strong sunlight maximizes solar energy conversion efficiency.
- Install the lamp in areas requiring illumination, such as paths, garages, and backyards, ensuring easy access to sunlight.
- Long press for 1 second to activate MODE 1: Induction mode (lamp turns on when motion is detected and turns off after 15s).
- Press again to enter MODE 2: Induction + dim light mode (lamp turns on after motion detection, then dims after 15 seconds).
- Press the third time to enter MODE 3: Dim light mode (lamp emits a low light continuously regardless of motion).
Note: If sunlight or other light sources
are detected on the solar panel, the lamp will not turn on even if the ON/OFF
switch is toggled. During testing, cover the solar panel to activate the lamp
after turning on the ON/OFF switch.
Secure the device using the provided screws. Installation methods may vary
depending on conditions, but ensure the solar panel is not positioned upside
down, as this affects solar charging effectiveness during daylight.
INSTRUCTIONS FOR RECYCLING AND DISPOSAL:
This label means that the product cannot be disposed of as other household
waste throughout the EU. To prevent potential damage to the environment or
human health from uncontrolled waste disposal. Recycle responsibly to promote
the sustainable use of material resources. If you want to return a used
device, use the drop-off and collection system, or contact the retailer from
whom you bought the product. The retailer can accept the product for
environmentally safe recycling.
**** A declaration by the manufacturer that the product complies with the
requirements of the applicable EU Directives.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>