Dermaroller S50 UV-LED Lamp with Battery User Manual
- June 3, 2024
- Dermaroller
Table of Contents
S50 UV-LED Lamp with Battery
User Manual
Technical data:
Power supply: nominal input: 100-240V, 50-60Hz 1A
rated output: DC12.6V 1.5A
Power: 54W
Charging time: 3h
Continuous operation time: 10h
Number of UV LEDs: 30pcs
UV wavelength: 365+405nm
Model: S50
Certificate no: CTB211129011SX-ZS/CTB211124030EX-ZS Cures hybrids/UV/LED gels.
Parts instruction:
- Infrared Induction
- LED Screen
- 30s Timer Touch Key
- 60s Timer Touch Key
- Low Heat Mode 99s
- Power button
- Power connector
- USB port
User Manual:
- Connect the lamp to the power supply. The indicator on the display will flicker, indicating that the lamp is charging. Three flashes and a pause indicate that the lamp has been charged. The unit should then be disconnected from the power supply.
- A short press of the power button will turn the lamp on, a long press will turn it off. Pressing the power button briefly several times will show the lamp’s charging status.
- To start the illumination, press the timer button – you can select one of the available timer options 30s/60s/99s(Low Heat mode), or start without selecting a time. To do this, insert your hand into the device, and the illumination will start automatically when the sensor detects movement(the illumination limit is 99s).
- The display shows the remaining exposure time. When using the 30s/60s timer, it counts down. When using the 99s timer and activating the device with the motion sensor, the device counts up.
- Follow the curing instructions of the product used.
- When the display starts to flicker, this indicates a low charge and the lamp should be connected to a power source as soon as possible.
- Two USB ports provide 5V 1 A output voltage and can provide power for other devices, such as a smartphone.
- When you have finished using the lamp, turn it off and unplug it from the mains.
Warnings:
-
The lamp should be operated only from an appropriate power source.
-
Protect the unit from dust, water and other liquids.
-
Unplug the lamp from the power source when the lamp is not in use or there is a need to clean it. Do not use the lamp:
– In humid areas.
– If the power adapter is damaged.
– If the unit or the connecting cable is damaged.
– If the timer buttons do not work. -
The device should not be left running for more than 600s, as this may reduce its service life. The device is designed for indoor use.
-
Making independent switches and changes to the device is prohibited.
-
Opening the device is categorically prohibited and equivalent to loss of warranty, and the manufacturer assumes no responsibility for the correct and safe operation of the device.
-
Do not stare directly into the UV light, which can cause eye damage. The lamp uses UV/LEDs, which emit dangerous UV rays. These can also cause damage to the skin. Your skin may be more sensitive to UV rays when taking medications or using cosmetics. If you notice sudden changes on your skin, seek medical advice immediately.
-
Slight heating may occur while the device is charging.
-
If the device is not used for a long time, charge it at least once every 3 months.
-
If the device does not fully charge for a long time, unplug it immediately.
-
If electrolytes escape from the device, immediately wash the soiled areas with plenty of water and protect them.
-
Do not charge the lamp when it is not under supervision. When walking away from the lamp, unplug it from the power supply.
-
KEEP OUT OF REACH OF CHILDREN.