2A3J8-BKP Wireless Microphone Instruction Manual

2A3J8-BKP Wireless Microphone

Specifications:

• Type: UHF Wireless Microphone
• Frequency Response: Dynamic 50Hz-16KHz
• Polar Pattern: Cardioid
• Output Impedance: 600 Ohms
• Sensitivity: -52dB ±1 dB
• S/N Ratio: 96dB
• Input Sample Rate: 48KHz
• Bit Depth: 24-bit
• Total Harmonic Distortion: 0.05%

Product Usage Instructions:

1. Setup:

Connect the microphone head section, including the microphone
cover net and microphone cartridge module, to the main body. Use
the provided USB cable for charging.

2. Power On/Off:

Press the Power Button to turn on the microphone. The blue light
indicates the boot state. Press and hold the Power Button to turn
off the microphone.

3. Adjusting Volume:

Use the Volume + Button to increase the volume and the Volume –
Button to decrease the volume.

4. Monitoring:

Observe the Working Indicator Light for status. A flashing blue
light indicates no connection, a steady blue light indicates the
receiver is connected, and normal audio signals are being
received.

5. Connectivity:

Utilize the Type-C Interface for connecting to compatible
devices.

FAQ (Frequently Asked Questions):

Q: How do I charge the microphone?

A: Connect the provided USB cable to the microphone for
charging.

Q: What is the significance of the blue light?

A: The blue light indicates different states – boot state, power
status, and connection status of the receiver.

Q: How do I adjust the volume?

A: Use the Volume + Button to increase volume and the Volume –
Button to decrease volume.

—

-:11.i]J··· I

l’vr1r&W 1

—-±1. I
+ – _.,.· –
— lu c I
–IC L

—-1nu'”u–·’`
± IJ.
±IJ I –
I- ..
Iu · I
5

]

l

J ;

T l

l,

j

I+ ]]

I+ ,]]

L

`
+I ‘]

I2[

±], ,l

— +.J),

+-1

-‘J,:J

–

1_
]

2: ,A[ I
– —–s’! — —–Is,L)
–L — u -1
— :i l] -L,J

[I “_:[] I — ,U
–)

lDI J03C:1 :J11,AJ[I[

I

. ·
=lt

+I /[

+I

L
4

+I

[

‘l/ ]

! l /

– :
I
+I v` fl /

I +fJ
-1

+I I
—

1’1 II
IJ ]I] +··..
-j

41][
J –L’

±II

–[
–I
-L ,

Type Frequency Rponse.
Polar Pattern: Output Impedance:
Sensitivity:
S/N Ratio: Input Sample Rate:
Bit Rate THl»N:

Dynamic 50Hz-16KHz
Cardioid 6000 -52dB:t1 SdB 96dB 48KHz 24btt 0.05%

NOTES

@

w

n

g

t h

u

o

s.m

.m t

e

s a w “.

g

s o

u8 r

P.

w

iot

rm

e

o

d
nte

wa t

w

m

wf r

@ @

Dt

a

cp l a s u s
t ee d e c e h

p

l

s t

a

.eci rW d
a “. t o

I g

m

e

FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions (1) This device may not cause harmful interference (2) This device must accept any intecaeence received, including intecaerence that may cause undesied operation. 2, Changes or modifications not expressly approved by the paca£ responsible for compliance could void the uses authority to operate the equipment NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause hamful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television eception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the Consult the dealer or an experienced radio/TV technician fo help. RF warning statement The device has been evaluated to meet general RF exposure requirement, The device can be used in portable exposure condition without restriction.

: INSTRUCTION MANUAL] UHF WIRELESS MICROPHONE

MM: MM:

D AABaca¬nes·4

6.35mm to 3.5mm Adapter’1

– –

@ – – i

:

[

gg DD WirelessReceiver·1

Microphone’2

USB Cable’1

Anti-slip Rings·2

II

Foam Covers·2

ID Microphone head Section: Including Microphone Cover Net and Microphone Cart1ndge Module
msplay Sccaen Display ca´rking channels, batteca¤ power, fcauency.
®Switch buca«on: Press for 3 seconds on/ca lhe miphone
II @ Frequenadjust buca®n.

l

/©

@ Gl

— CDVolume +Button

Press this button, increase the volume

— @Volume – Button –ess this bucan, reduce the volume

@Perl1ght

Boot state, the blue light normally on; Low pcaer

sca©e, the red light caashing; Charging, the red light

normally on (Chaca ed, a blue light normally on)

@Working Indicator Light

– Recer not conned, the blue light caash; Receiver 1s connecaved, the blue light

nocaally on; nonnal receive audio signals,

—— @6.35mm Audio Poca¢
@Type-C Interface (i)PowerButton

the blue caash Inseca¡ the dfWice boot canused Chag1ng interface Press this button, the indicator light on and ready car use.

II

1

2

3

4

5 2mm

6 1.0 (1.0) 1.0

4

3

2

BKP-20 (

LOGO) (

xxxxx xxxxx xxxxx xxxxx

xxxx-xx-xx xx xx-xx-xx xx xx-xx-xx xx xx-xx-xx

TZ-YS-KP2001 V1 1

B

1 ·· l mm

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>