ADCOPE AD1000BT Headphones User Manual
- June 2, 2024
- ADCOPE
Table of Contents
User Manual HEADPHONES
MODEL:AD1000BT
Packages
Diagram
Power On / Off
-
Power ON:
Press and hold the ” ****” for 2s, the blue light will come on and you will hear a voice prompt ” Power On “. -
Power OFF:
Press and hold the ” ****” for 5s, the red light will come on for a second and you will hear a voice prompt ” Power off “.
How to pair
- With your headphones powered off, press and hold the pause/play button until the red and blue lights flash alternately to enter the pairing mode, and then you will hear a voice prompt ” Pairing “.
- Enable the Bluetooth feature of your cellphone and find “AD-1000BT” to connect. Once paired, you will hear “Connected”.
Answer / Hang up / Redial / Reject a call
Clear Paring Record
With your
headphones powered on,press and hold the ” + ” and ” – “buttons simultaneously
for 5s,until the red and blue light flashes 3 times and the headphones will re-
enter into paring mode.
Charging Indications
Charge for 2 hours. Once fully charged the indicator
will turn blue.
Bluetooth Indicator Light & Voice Indication
| State | Indicator Light | Voice Indication |
|---|---|---|
| Power on | Blue light stays on for 1s | Power on |
| Power off | Red light stays on for 1s and turns off | Power off |
| Pairing Mode | Red and blue light flashes alternatively | Pairing |
| Bluetooth Connected | Connected | |
| Bluetooth Disconnection | Disconnected | |
| In Charging | Red light stays on in charging, blue light stays on in full | |
| charge |
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure statement
The device has been evaluatec to meel general RF exposure requirement. The
device can be used in porlable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>