Godox LED 64 LED Video Light Instruction Manual

Godox LED 64 LED Video Light

Foreword

Thank you for purchasing this Godox Product!
LED64 video light is excellent for macrophotography, product shooting, and video recording, etc. This lightweight and portable light provides high brightness and accurate color temperature.

You can flexibly control the light brightness by using the dimmer and by interlocking multiple lights.

Warning

 Always keep this product dry. Do not use in rain or in damp conditions.
 Do not disassemble. Should repairs become necessary, this product must be sent to an authorized maintenance center.
 Keep out of reach of children.
 As this product do not have waterproof function, please take measures of waterproof in rainy or damp environment.
 Do not use or store the product if the ambient temperature reads over 50°C.
 Do not use the flash unit in the presence of flammable gases, chemicals and other similar materials. In certain circumstance, these materials may be sensitive to the strong light emitting from this flash unit and fire or electromagnetic interference may result.
 Observe precautions when handling batteries

• Do not put batteries into a fire or apply direct heat to them.
• Batteries are prone to leakage when fully discharged. To avoid damage to the product, be sure to remove batteries when the product is not used for a long time or when batteries run out of charge.
• Should liquid from the batteries come into contact with skin or clothing, rinse immediately with fresh water.

Parts

1. 64 LED Beads
2. Power Switch
3. Brightness Controller
4. Battery Compartment Lock
5. Light Hots hoe Connection
6. Locking Ring
7. Camera Hotshot Connection
8. DC Power Jack
9. 1/4″ Bracket Mounting Hole
   

Installation and Operation

1. Installing the Video Light

   • Screw the Locking Ring (06) to the highest point and insert the Camera Hotshoe Connection horizontally into the hotshoe of a camera or a camcorder.
   • Tighten the Locking Ring (06).
     
     Note: If your camcorder has no hotshoe connection, you are advised to purchase a connecting bracket for camcorder. The video light has a 1/4″ Bracket Mounting Hole as your camcorder does. Therefore, you can easily connect both the light and the camcorder to the bracket.

2. Using the Video Light

   • Slide the Battery Compartment Lock (04) to the right and open the compartment.
     

   • Install batteries (4*AA) according to indications in the compartment and then lock it.
     

   • Switch the power on, the video light giving out light.
     

   • Turn the Brightness Controller (03) to adjust the brightness.
     
     Instead of AA batteries, the light can use AC power by using the DC Power Jack. Connect the video light to AC power using a 5V charger (purchased separately). Then switch the light on to start working.

3. Interlocking Multiple Video Lights Through the Light Hotshoe Connection (05) and Camera Hotshoe Connection (07), multiple video lights can be interlocked together to strengthen the lighting brightness and get a better control of the lighting effects.

Technical Data

Product design and specifications are subject to change without notice.

Customer Support

Declaration of Conformity
GODOX Photo Equipment Co.,Ltd. hereby declares that this equipment are in compliance with the essential requirements and other relevant provisions of Directive 2014/30/EU. They are allowed to be used in all EU member states.
For more information of DoC, Please click this web link:
https://www.godox.com/DOC/Godox_LED36_LED64_DOC.pdf

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>