Keyian V22858L Kids Microphone Instruction Manual
- May 15, 2024
- Keyian
Table of Contents
Keyian V22858L Kids Microphone
Product Information
Specifications
- Model: KidsMicrophone
- Compliance: FCC Part 15
- RF Exposure: General exposure requirements met
- Usage: Portable exposure condition without restriction
Product Usage Instructions
Safety Precautions
- Before using the KidsMicrophone, please read the instruction manual carefully.
Powering On
- To power on the microphone, press and hold the power button for 3 seconds until the indicator light turns on.
Adjusting Volume
- You can adjust the volume by rotating the volume control dial located on the microphone body.
Connectivity
- Connect the microphone to your device using the provided cable. Ensure a secure connection for optimal performance.
Usage:
- Hold the microphone close to your mouth when speaking or singing for the best sound quality.
Frequently Asked Questions (FAQ)
Q: Is the KidsMicrophone suitable for outdoor use?
- A: Yes, the device can be used in portable exposure conditions without any restrictions, making it suitable for outdoor use.
Q: How do I charge the KidsMicrophone?
- A: The KidsMicrophone is powered by batteries. To replace them, open the battery compartment and insert new batteries following the correct polarity.
Buttons Operation
- Hoid: ON/OFF Press: Mode switching
- Press: the previous song under MP3 mode.
- Under selfie mode, press it to enable the selfie function (only for iOS system mobile phones)
- Press: the previous song under MP3 mode.
- Under selfie mode, press it to enable the selfie function (only for Android system mobile phones)
- Press: Play/Pause. Under the state, hold it for automatic search
- MIC/Replay
- Press: Mike ON/OFF
- Hold: Replay function under TF card play mode
- VOL + ” Increase music volume
- VOL— ” Decrease music volume
- MIC + ” and ” MIC ” Gradually push to adjust the sound of the mic
- REMIX – ” Gradually push to make your voice better
Wireless Karaoke
- Supply power: Hold the button to start the product.
- Wireless connection: enable the wireless of mobile phone, click to connect, successful connection if a prompt tone is produced.
- Adjust sound: adjust the sound volume of the mike and the reverberation to a suitable level.
- Start Karaoke
Bluetooth Speaker Function
- Plug the TF card and music and play music, the microphone can be used as a Bluetooth speaker.
- Short press to switch the music modes (Original sing/Accompaniment)
Recording with mobile phone
- Connect the recording wire: insert the MICRO plug of the recording wire into the MICRO interface of Karaoke Treasure, and the 3.5mm interface into the earphone jack of the mobile phone.
- Open the Karaoke software on the mobile phone, such as: USING, Kugou Music, or other recording APPs, select your favorite song, and record the song according to the above-mentioned singing method.
- Test and save the song: operate according to the instructions of Karaoke software.
Selfie function
- Press the button to switch from wireless mode to selfie mode;
- Enable wireless in the mobile phone, search “shutter”, and click connection;
- Open the photograph interface of the mobile phone, and press the or button to take photos.
Note: 4.2.2 or higher version for Android system, 6.0 or higher version for iOS system, it doesn’t support other versions temporarily. It doesn’t support the mobile phone which has the independent and solid photograph button.
Technical Parameters
- Output Power: 5W
- Frequency Range: 100HZ~10KHZ
- Max Sound Pressure Level: >115DB 1KHZ TDH < 1%
- Reverberation Mode: sound effect reverberation
- Power Supply: Built-in 18650 Li-battery
- Battery Capacity: 2500mAh
- Charging Power: DC5V
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.