Kleenwater CFS6135-C-SUSA Softening Filtration System Instruction Manual

May 15, 2024
Kleenwater

Water Filter Systems
Food Service
INSTR4167 0403
Installation of CFS6135-C-SUSA Softening/Filtration System
Built-in Shut-off and Flush Valve System

CFS6135-C-SUSA Softening Filtration System

  1. Apply Teflon® to thread on flush valve. Screw flush valve into filter head marked as “outlet”. Screw it in until tight and parallel to bracket.

  2. Connect the cartridge to filter head. Push all the way in and twist so that the notch on the cartridge lines up with the “ON” position onthe head.

  3. Mount filter bracket to wall with screws. Make sure there are 2-3 inches of clearance between the bottom of the filter and the bottom of the cabinet. This clearance is needed to exchange the cartridge.

  4. Run 3/8 inch blue plastic tube from water supply valve to filter inlet. Make sure to push tube all the way into quick connector.

  5. Connect metal braided water hose from espresso machine to filter using 1-2 feet of 3/8 inch blue plastic tubing.

  6. Connect small flush hose to small fitting and point flush tube into drain pipe.

  7. Turn arrow on flush valve handle towards the small flush tube (see arrow on top of the valve). Turn on water supply and flush for about 1 minute.

  8. Turn arrow on flush valve handle towards the 3/8″ inlet to the machine. Check for leaks around filter.

Teflon is a registered trademark of E.I. DuPont.

Schaerer USA Corporation, 2900 Orange Ave. Suite #102, Signal Hill, CA 90755 • Phone: 888-989-3004 • www.schaererusa.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals