DuroBumps DBF212 Front Off Road Bump Stops Installation Guide
- May 15, 2024
- DuroBumps
Table of Contents
DuroBumps DBF212 Front Off Road Bump Stops
Product Specifications
- Part Number: DBF212
- Product Name: Front Bump Stops
- Includes:
- (2) Two front DuroBumps
- (2) Two JIS 10.9 M10 1.25 mm x 35 mm flange bolts
- (1) One FREE sticker
Product Usage Instructions
Step 1: Prepare for Installation
Pre-soak the OEM bump stop with penetrating oil to ease removal.
Use a properly rated jack to raise the front of the vehicle and support the
frame rails with jack stands. Remove the front wheels from the truck.
Step 2: Remove OEM Bump Stops
Remove the OEM bump stops using groove-lock pliers, a pipe wrench, or similar
tools. Be cautious not to damage the threaded stud during removal.
Step 3: Clean Frame
Use a scraper or wire brush to clean any mud or debris from the frame where
the new bump stops will be installed.
Step 4: Install New Front DuroBumps
Insert the provided flange bolts into the new front DuroBumps.
Step 5: Mount New DuroBumps
Using a 14 mm deep socket, install the new DuroBumps in the OEM location.
Tighten the bolt until snug, ensuring not to over-tighten.
Step 6: Complete Installation
Reinstall the wheels and lower the vehicle. Remember to tighten the lug nuts
according to the vehicle manufacturer’s recommendations.
Now you are ready to hit the trails or enjoy your ride!
What’s included
- (2) Two front DuroBumps
- (2) Two JIS 10.9 M10 1.25 mm x 35 mm flange bolts
- (1) One FREE sticker
Tools Required:
- Jack and jack stands
- Lug wrench OR 19 mm deep socket
- Groove-lock pliers, pipe wrench, or similar
- Scraper or wire brush to clean debris
- 14 mm deep socket
- Torque wrench
Instructions
Pre-soak OEM bump stop with penetrating oil to make removal easier. Pay extra attention to the threaded stud that mounts the bump stop to the frame and the threads of the stud that are exposed beyond the nut.
Step 1: Following vehicle manufacturer recommendations, use a properly rated jack. Raise the front of the vehicle and support the frame rails with jack stands. Remove front wheels from truck. Be sure to use jack stands!
Step 2: Remove OEM bump stops with groove-lock pliers, pipe wrench, or similar. Pay careful attention during removal to be sure you do not break the threaded stud on the OEM bump stop during removal.
Step 3: Use a scraper or wire brush and clean any mud/debris from the frame.
Step 4: Insert provided flange bolt into the new front DuroBumps.
Step 5: Using a 14 mm deep socket, install new DuroBumps in the OEM location. Tighten the bolt until snug. Do not over-tighten.
Step 6: Reinstall wheels and lower vehicle back to the ground. Be sure to tighten lug nuts to vehicle manufacturer’s recommendations.
Now go hit some trails or cruise the mall … whatever you’re into!
MADE IN THE U.S.A.
www.DuroBumps.com
Frequently Asked Questions (FAQ)
Can these front bump stops be used on all vehicles?
These bump stops are designed for specific vehicle models. Please check compatibility before purchase.
What should I do if I encounter resistance during installation?
Stop immediately and assess the situation. Ensure proper alignment and threading before proceeding to avoid damage.
Are additional tools required for installation?
Basic hand tools such as a jack, jack stands, pliers, and a socket set are recommended for installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>