DuroBumps DBF2T Front off Road Bump Stops Instruction Manual
- May 15, 2024
- DuroBumps
Table of Contents
Premium Bump Stops
Proudly Made in the USA
INSTALLATION INSTRUCTIONS
Part# DBF2T, DBF17T – Front Bump Stops
What’s included:
(2) Two front DuroBumps Premium bump stops
(2) Two JIS 10.9 M10 1.25 mm x 35 mm flange bolts
(1) One FREE sticker
Tools Required:
• Jack and jack stands
• Lug wrench OR 19 mm deep socket
• Groove-lock pliers, pipe wrench, or similar| • Scraper or wire brush to
clean debris
• 14 mm deep socket
• Torque wrench
---|---
Instructions:
Pre-soak OEM bump stop with penetrating oil to make removal easier. Pay
careful attention to the threaded stud that mounts the bump stop to the frame
and the threads of the stud that are exposed beyond the nut.
Step 1: Following vehicle manufacturer recommendations, use a properly rated
jack.Raise the front of the vehicle, and support the frame rails with jack
stands. Remove front wheels from truck. Be sure to use jack stands!
Step 2: Both Passenger and driver side of the vehicle have (2) OEM bump stops
per side located on the frame rail above the Lower Control Arm.Remove the rear
OEM bump stops with groove-lock pliers, pipe wrench, or similar.Be careful not
to break the threaded stud on the OEM bump stop during removal.
Step 3: Use a scraper or wire brush and clean any mud/ debris from the frame.
Step 4: Insert provided flange bolt into the new front DuroBumps.
Step 5: Install the DuroBumps at the rear of the lower control arm, using a
14mm deep socket. Tighten the bolt until snug.
Do not over tighten. The OEM bump stop that is located at the front of the
lower control arm will remain in place.
Step 6: Reinstall wheels and lower vehicle back to the ground. Be sure to
tighten lug nuts to vehicle manufacturer’s recommendations.
Please note: DuroBumps are intended to be installed at the rear of the
lower control arm only.
Now go hit some trails or cruise the mall … whatever you’re into!
MADE IN THE U.S.A.
www.DuroBumps.com