Gosvor 2024 Upgrade Pivot Cordless Robotic Pool Cleaner User Manual

Gosvor 2024 Upgrade Pivot Cordless Robotic Pool Cleaner

Specifications

• Model: Gosvor Pivot Cordless Pool Vacuum
• Rated Working Voltage: 12V
• Power: 100W
• Battery Life: Up to 90 minutes
• Charger Input: 100-240V AC, 50/60Hz
• Charger Output: 12V DC, 1A
• Battery Capacity: 2000mAh
• Charging Time: Approximately 4-6 hours
• Pool Size: Suitable for pools up to 20ft x 40ft
• Filter Capacity: 1 liter
• Filter Density: Fine mesh filter
• Moving Speed: Adjustable
• Waterproof Grade: IPX8
• Pool Water Temperature: Suitable for 50°F to 104°F
• Pool Water PH Value: 7.2 to 7.8
• Charging Environment: Indoor, cool and dry place

Product Usage Instructions

Getting Started

1. Ensure the device is fully charged before use.
2. Place the vacuum in the pool water and turn it on using the power button.
3. Allow the vacuum to move around the pool walls and floor to clean efficiently.

Cleaning the Filter Bag

1. Turn off the vacuum and remove it from the pool.
2. Open the filter compartment and take out the filter bag.
3. Rinse the filter bag with clean water to remove debris.
4. Allow the filter bag to dry completely before reinserting it into the vacuum.

Cleaning the Rotor

1. Turn off the vacuum and remove it from the pool.
2. Clean the rotor using a soft brush to remove any dirt or debris.
3. Ensure the rotor spins freely without any obstructions.

Frequently Asked Questions (FAQ)

• Q: How often should I clean the filter bag?
  A: It is recommended to clean the filter bag after each use to maintain optimal performance.

• Q: Can the vacuum be used in hot tubs?
  A: No, the Gosvor Pivot Cordless Pool Vacuum is designed for use in swimming pools only.

• Q: What should I do if the vacuum stops working?
  A: Check the battery charge, clean the filter bag and rotor, and ensure there are no obstructions blocking the vacuum’s movement.

Thank you for choosing the Gosvor Pivot Cordless Pool Vacuum. Please take a few moments to read through this user manual.
lf you have any questions, please contact our customerservice team.

Gosvor Customer Service:

US Toll Free:866-866-8806
Email: Service@gosvor.com

Important Precautions

When installing and using this electrical equipment, basic safety precautions should always be followed, including the following:

1. Read the manual carefully and use the product according to the instructions.Gosvor will not be held responsible for any loss or injury caused by improperuse or care of this device.
2. Only use authorized accessories recommended or sold by the manufacturer approved affiliates
3. Ensure that children do not attempt to access cleaner while it is operating
4. Only use 36112 adapters for the device.
5. If needed, the adapter cord should only be replaced by a qualified electrician.
6. Do not turn on the device when it is out of the pool.
7. The charging adapter must be connected to a surge protector when charging.
8. Do not operate the cleaner when people or animals are in the pool.
9. Always clean and wash the filter tray after using the device.
10. Turn off the cleaner when performing maintenance on or cleaning the device.
11. The cleaner should be stored in a cool and well-ventilated place, away fromdirect sunlight.
12. While charging, the cleaner should be kept in a cool place and not directly covered by cloth or other objects, as this may overheat components in the device.
13. Only certified professionals are permitted to disassemble the sealed driv-ing kitof the cleaner.
14. Do not operate the device while the pool filter is running.
15. The motor’s oil sealing contains grease, which may cause a small discharge increase if the component is damaged.
16. The device is only suitable for swimming pools up to 1292sq.ft (120m2). Usingthe device on larger pools may reduce the cleaning effectiveness.
17. lf the cleaner needs to be stored for an extended period of time, it should becharged every three months to maintain battery life between 40%-60%. If thecleaner is not charged for an extended period, the battery voltage may lower toevels that could be dangerous when recharging.
18. Do not use or store the cleaner near any heat source
19. Do not pierce, bludgeon, or throw the device, as this may cause irrep-cable damage.
20. Make sure the charging socket is dried before charging
21. Do not bury the charging cable.
22. Ensure the device is turned off before attempting to charge the device.
23. If this device is damaged, liquid may leak from the battery and should not be touched.
24. If the device is damaged, cease operations immediately.
25. Do not modify or attempt to replace the battery pack.

SAVE THESE INSTRUCTIONS.

Introduction

The Gosvor Pivot is an energy-saving, environmentally friendly Cordless Pool Vacuum. Highly efficient, this device can clean pool walls and floors automatically without replacing the pool water.

Read this user manual carefully before use.

Specifications

1. Model| Gosvor Pivot|
---|---|---
2. Rated Working Voltage| 25.9V|
3. Power| 90W|
4. Battery Life| 100 Minutes
5. Charger Input| 100~240V, 50/60Hz
6. Charger Output| 25V/1A
7. Battery Capacity| 2600mAh x 6|
8. Charging Time| 3 Hours
9. Pool Size| 100m²/1076sq.ft
10. Filter Capacity| 71GPM(267LPM)
11. Filter Density| 180μm
12. Moving Speed| 32.8ft/min (10m/min)
13. Waterproof Grade| IPX8
14. Pool Water Temperature| 50°F~77°F (10°C~25°C)
15. Pool Water PH Value| 7.0~7.4
16. Charging Environment Temperature| 41°F~95°F (5°C~35°C)
17. Max Water Depth| 3m (10feet)
18. Product Size| 430(L)x390(W)x220(H) mm
19. Storage Temperature| -4°F~113°F (-20°C~45°C), RH ≦ 75%

Operations

Getting Started

1. Find a working electrical outlet.

2. Wipe the charging port with a towel to prevent water from entering the charging port.

3. Twist off the plastic cap to plug in the charging cord.

4. The charger indicator light will turn red, indicating the device is charging. Allow 3 hours to fully charge your device, at which time the indicator will turn green. Charging takes 3 hours to charge the device fully. The indicator light will turn green when charging is complete.

5. Unplug the charger and screw the plastic cap onto the device ensuring a firm fit. Now you’re ready!
   WARNING: Do not operate the device out of the water as it may damage some components.

6. At your pool, press the button, and the blue LED indicator will blink for ten seconds. Place your device into the water, and rock it side-to-side to help any air trapped in the body to escape, then fully submerge the device.

7. If you need to stop the cleaning process for any reason, you can manually shut the device down by pressing the button for three seconds.

8. After your device has completed its cleaning cycle, it will automatically park near your pool’s wall. Use the provided hook to retrieve the device.

Cleaning the Filter Bag

1. Place the device on the ground, top side down.
2. Press the two red tabs at the front of the device inwards and towards the front.
3. Press in the two red clips at the read and lift up the lid.
4. Pull the red ribbon near the front marked “PULL TO REMOVE BAG.”
5. Empty any debris inside the bag.
6. Flip the bag inside out and use a hose to spray the bag to remove any lingering debris. In some instances, washing the bag by hand may be necessary.
7. Hose clean the lid and body of the device.
8. Return the bag to its original position and return the cleaned filter back into the lid.
9. Starting with the sides, attach the lid back to the device’s body and secure the tabs in reverse order. Ensure the body is properly latched and snuggly fits with the base of the device.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>