Electriflex CEHD50 Commercial Electric Water Heater User Manual

Electriflex CEHD50 Commercial Electric Water Heater

Product Information

Specifications:

• Product: NSF Construction Commercial Electric Water Heater
• Models Available: CEHD50 (3 & 6 ELEM), CEHD80 (3 & 6 ELEM), CEHD120 (3 & 6 ELEM), CEHD50 (9 ELEM), CEHD80 (9 ELEM), CEHD120 (9 ELEM)
• NSF Kit Part Numbers:
  • CEHD50 (3 & 6 ELEM) – 265-44542-06
  • CEHD80 (3 & 6 ELEM) – 265-44542-07
  • CEHD120 (3 & 6 ELEM) – 265-44542-08
  • CEHD50 (9 ELEM) – 265-44542-09
  • CEHD80 (9 ELEM) – 265-44542-10
  • CEHD120 (9 ELEM) – 265-44542-11

Frequently Asked Questions

• Q: Can I install the NSF construction components myself?
  • A: For safety and convenience, it is recommended to have a qualified technician install and service the NSF construction components.
• Q: What should I do if the correct NSF kit is not provided for my water heater model?
  • A: Ensure that the correct NSF kit specified for your water heater model is provided before proceeding with installation. Contact the manufacturer or supplier for assistance.
• Q: Is it necessary to seal the water heater to the floor?
  • A: Yes, it is important to seal the water heater to the floor using RTV sealant to prevent any leaks and ensure proper installation.

THE MANUFACTURER OF THIS WATER HEATER WILL NOT BE LIABLE FOR ANY DAMAGE RESULTING FROM FAILURE TO COMPLY WITH THESE INSTRUCTIONS. READ THESE INSTRUCTIONS THOROUGHLY BEFORE STARTING.

For safety and convenience, the NSF construction components must be installed and serviced by a qualified technician

Before proceeding with the installation of this NSF kit, please ensure that this water heater has been installed in accordance with local codes and/or ordinances. In the absence of local codes, this water heater must be installed in accordance with the National Electric Code – latest edition. Refer to the Installation instructions provided with this water heater. Assure the correct NSF kit for this water heater has been provided.

NSF Kit Required

Model| NSF Kit Part No.
CEHD50 (3 & 6 ELEM)| 265-44542-06
CEHD80 (3 & 6 ELEM)| 265-44542-07
CEHD120 (3 & 6 ELEM)| 265-44542-08
CEHD50 (9 ELEM)| 265-44542-09
CEHD80 (9 ELEM)| 265-44542-10
CEHD120 (9 ELEM)| 265-44542-11

Tools and Materials Required

• sealant (provided)
• Control box seal (provided)
• Two (2) sheet metal screws (provided)
• NSF label (provided) attached to these instructions
• Caulk gun
• ¼” nut driver and/or drive tool

Installation Procedure

1. Place the control box seal on top of the control box sealing gap between the control box and water heater jacket. Attach the control box seal to the control box using two (2) sheet metal screws (see Figure 1).
2. Seal the water heater to the floor using RTV sealant. Be sure to seal the water heater completely to floor without leaving voids (see Figure 2).
3. Place NSF label on or adjacent to the rating plate

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>