Comfytemp K7006011 Wearable Heated Blanket Electric Throw User Manual

May 15, 2024
Comfytemp

Comfytemp K7006011 Wearable Heated Blanket Electric Throw

Comfytemp-K7006011-Wearable-Heated-Blanket-Electric-Throw-
PRODUCT

Specifications

Item Name Electrical Heated Throw
Product Weight 0.7kg/1.54Lb
Product Size 170 x 48 cm/67 x19 inch
Material Flannel

Cable Length

|

9.5 FT/ 2.9 M

Voltage

|

AC 110~120V 60Hz

Rated Power| 100W
Auto-off time| 4 Hours
Heating Level| Low, Mid, High

Package Included

| 1x Heated Throw 1x Controller

1x User Manual

Dimensions are measured manually, actual measurements may vary.

Product Diagram

Comfytemp-K7006011-Wearable-Heated-Blanket-Electric-Throw-
FIG-1

Instruction For Use

  1. Before the power cord is plugged in, please make sure that the coupler is connected.
  2. Contact the heating throw with the electrical outlet.
  3. Press the button to turn on the heating throw.
  4. Press the button successively to choose low/mid/high heat as you like.
  5. Over-temperature protection: If the blanket temperature becomes too high, the over-temperature protection on seng will be activated, and the three indicator lights on the controller will flash frequently. Please disconnect the power supply and wait for the temperature inside the blanket to decrease before resuming normal use.

Washing Instructions

  1. Disconnect the heating throw from the electrical outlet.

  2. Detach the throw connector from the control connector.

  3. Wash by hand or as follows in the automated washer using slow agitation and normal spin speed: Fill the washer with warm water. Add a minimum amount of all-purpose detergent, agitate to dissolve, and measure bedding before washing. Add bedding and soak for five minutes. Agitate for two minutes.
    Spin. Fill for cool rinse, agitate for one minute then spin.

  4. Dry in an automatic dryer on high heat, for five minutes only, or line dry. Remove damp bedding from the dryer, block to the original size, and drape to finish drying. Do not iron your bedding.

Danger

  1. Be sure to read carefully the accompanying instructions booklet before using this bedding.
  2. Do not use this bedding with an infant, an immobile person, or anyone insensible to heat, such as a person with poor blood circulation (this item may be omitted in the case of a mattress, mattress pad, or foot warmer).
  3. Do not tuck in the wired area of this bedding (this item may be omitted in the case of a mattress).
  4. Do not route electrical cords between the mattress and the box spring. Do not allow the cords to be pinched.
  5. Keep the control away from dray areas that may become damp such as an open window.
  6. Do not use pins – They may damage the electric wiring.
  7. Be sure that this bedding is used on an alternangcurrent supply circuit of the proper voltage.
  8. Turn off or unplug when not in use.
  9. Excessive healing may result from folding bedding, other than a mattress, when in actual use.
  10. If improper operaon of this bedding is observed, discontinue its use immediately and consult the manufacturer or the dealer regarding its repair.
  11. For throw blankets only: Do not use with rocking chairs, recliners, chairs with casters or wheels, or other furniture subject to movement.
  12. Do not tuck the blanket or supply cord into a sofa or other furniture. All persons of the blanket or controller should be visible at all times.
  13. Wrapping of cord around the controller may damage the cord. Loop loosely when storing.
  14. Do not dry-clean this bedding. Cleaning solvents may have a deteriorating effect on the insulation of the heating element. This appliance has a polarized plug (one blade is wider than the other) as a safety feature. This plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

TROUBLESHOOTING

Comfytemp-K7006011-Wearable-Heated-Blanket-Electric-Throw-
FIG-15 Comfytemp-K7006011
-Wearable-Heated-Blanket-Electric-Throw-FIG-16 Comfytemp-K7006011-Wearable-Heated-Blanket-Electric-Throw-
FIG-17

If failure connues, disconnue use. See warranty information to contact Comfytemp Customer Service.

Warranty

  • 24Hrs Quick Customer Support
  • 30 Days Free Return
  • 365Days Warranty

If you have questions or concerns, don’t hesitate to contact us directly at: US Customer Services Hotline 1(833)990-0618 Monday to Friday, 9 AM to 5 PM EST Email: help@comfytemp.com.

CONTACT

  • www.comfytemp.com
  • Product Name: Electrical Heated Throw
  • Brand: Comfytemp
  • Model: K7006011/K7006111
  • Company Name: UKCA SERVICE LTD
  • Address: 21 Ellesmere Avenue, Worsley,
  • Manchester, UK, M28 0AL
  • E-mail: ukca.service@gmail.com
  • Company Name: TopToll GmbH
  • Address: Einsteinstr.2,Neuss 41464,
  • Germany USt-IdNr.:DE339651736
  • Email: toptollde@gmail.com.

Manufacturer

  • Shenzhen Yicaiwangluo Technology Co., Ltd
  • Company Name: Xincaishenzhendianzishangwuyouxiangongsi
  • Address: Yousong Second Industrial Zone, Fukang community,
  • Longhua, 416Rm, 4F, 3Bldg, 1980 Technology&Cultural Industry
  • Park Shenzhen GuangDongSheng 518000 CN

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals