VOLTME Innovations HP05W Hypercore Go 5K Wireless Power Bank User Guide

VOLTME Innovations HP05W Hypercore Go 5K Wireless Power Bank

Charge Your Phone or Tablet

Works Flawlessly with MagSafe Compatible Phone Cases

Charge Your Bluetooth Earphones or Smart Watches

1. Enter “low power” mode: Press and hold the power button for three seconds. The LED indicator will change to blinking.
2. Charge your devices recommended for smartwatches or Bluetooth earphones.
3. Exit “low power” mode: Press the power button again for three seconds or press the power button twice.

Recharge Your Hypercore Go 5K

• Recharge your Hypercore Go 5K via a PD charger (not included)

FOD: Foreign Object Detection

The indicator light will flash when foreign objects or devices that do not support wireless charging are detected by the sensor.

Follow us on social media for product information and warranty service :

• voltme.com
• support@voltme.com
• jp.voltme.com
• jp_support@voltme.com

Specifications

Attention

• Avoid extreme temperatures.
• Don’t be exposed to liquids.
• Avoid dropping.
• Don’t disassemble.

Customer Service

• 18-month limited warranty
• Lifetime technical support
• (US) +1(888) 643 8838 Mon-Fri 9:00 AM – 5:00 PM(PT)
• support@voltme.com jp_support@voltme.com
• Shenzhen Voltnex Innovations Technology Co., Ltd Room 3101, Tower 6, Tianan Cloud Park II, Bantian Street, Longgang District, Shenzhen, Guangdong, 518129, China

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used per the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

IC Caution
Radio Standards Specification RSS-Gen, issue 5 This device contains license- exempt transmitters)/receivers) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: This device may not cause interference. This device must accept any interference, including interference that may cause undesired operation of the device.

RF exposure statement:
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>