QINGYUAN TK-1010 Portable Battery Speaker User Manual
- May 15, 2024
- QINGYUAN
Table of Contents
QINGYUAN TK-1010 Portable Battery Speaker
Front panel
- AC power socket
- Charging Indicator
- RED= Charging Light
- off= Fully Charged
- DC interface (9V)
- AUX input
- TF card input
- USB Player
- MIC1/2: Microphone input
- MIC.VOL: Microphone volume control
- MODE: Short press for playing mode selection for Line, FM Radio, Bluetooth, USB, and TF card.
- MIC Priority: insert the microphone, then press the MIC PRIORITY button, when you speak to the microphone, the audio signal turns weak; when you do not speak to the microphone, audio signal turns normal.
- Previous song
- EQ adjustment
- Next song
- Play/Pause&TWS:(Wireless Bluetooth Connection: under bluetooth mode, press the TWS button for around 3 seconds to pair another TWS speaker; Under FM mode, lightly press Play/Pause&TWS to enter into automatic scan and all the scanned radio stations will be saved automatically.)
- Light mode selection & Light switch on/off button
- VOLUME Music volume adjust
- Power switch
Operating instructions
playing
Turn on the power switch, and adjust the main volume knob to the proper place.
Switch on, and EQ adjustment under your preferences. You then can enjoy the
wonderful & professional glamour brought by the product.
Karaoke performance
Plug in the microphone, and then turn the knobs to adjust the microphone
volume for optimizing the performance, press the power switch. Note: after
using, please turn down the volume first. Then switch off the power and pull
out the power plug.
FM Operation
Press the mode button to switch to FM mode, and short press the PLAY/PAUSE
button to automatically scan the radio station, by pressing PREVIOUS or NEXT
you can select a previous or next radio station.
Bluetooth
Press the MODE button on the panel control to select Bluetooth mode.
Simultaneously open the Bluetooth setting on your phone, tablet or any other
Bluetooth enabled audio device and select “TK-1010 “.
-
Power:
- 40W
Frequency Response
-
for the main speaker:
- 45Hz-20KHz
-
Power Supply:
- AC90-230V 50/60Hz
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction