LUXMANN CK-W06A-001 Microwave Induction Ceiling Light Instruction Manual
- June 4, 2024
- LUXMANN
Table of Contents
LUXMANN CK-W06A-001 Microwave Induction Ceiling Light
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble,
operate, or install the product. is light xture require 100-240VAC.All wiring
must be in accordance with the National Electrical Code (Canadian
Electrical Code in Canada). Some local electrical codes
WARNING
CAUTION
- Do not cut any wires that have factory installed wire connectors or remove the wire connectors.
PREPARATION
Before beginning installation of product, make sure all parts are present.
Compare parts with hardware contents list. If any part is missing or damaged,
do not attempt to assemble, install, or operate the product.
Tools Required for Assembly (not included): Phillips and meter, electrical
tape, silicone sealant, safety glasses, work gloves, and ladder
- Do not connect to dimmers or timers
- Above the groun
Estimated Installation Time: 30 minutes
HARDWARE CONTENTS
Note: Illustrations may vary from actual unit.
2x – Wire Connectors
| 2x – Decorative Nut (Pre-installed)|
2x – Mounting Screw
---|---|---
DISASSEMBLE LIGHT FIXTURE
-
- Remove cover from base.
- Remove cover from base.
LIGHT FIXTURE INSTALLATION
| or fuse. Place tape over circuit breaker switch and– – — – – –
–090-yj
---|---
- Tighten mounting screws fnger tight
- Attach mounting bracket to junction box using the two mounting bracket screws (supplied). Tighten securely.
WIRING THE LIGHT FIXTURE
Note: All wiring must be run in accordance with the Na- tional Electrical
Code through conduit or another accept – able means.
question as to the suitability of the system.
Twist the wires together and secure with wire connectors.
- Route the junction box ground wire through the large White holem next to the ground screw (GND). Attach the ground wire under the ground screw.
- Using the wire connectors:
• Connect all white wires together.
• Connect all black wires together
MOUNTING THE LIGHT FIXTURE
-
Make sure wire connectors and wires are inside the junction box.
-
Slide the xture base onto the mounting screw
-
Tighten the mounting screws securely against the light fixturc basc.
-
use the two decorative nut to install the light xture cover.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
etween the radiator & your body.
