RADIOMASTER RP4-TD Receiver User Manual
- May 15, 2024
- Radiomaster
Table of Contents
RADIOMASTER RP4-TD Receiver
Product Features
- Type: ISM
- MCU: ESP32
- RF Chip: SX1281 x 2
- Telemetry RF power: max 100mw x 2
- Antenna: 65mm 2.4GHz T Antenna x 2
- Frequency Range: 2400 MHz to 2480 MHz
- Maximum receive refresh rate: 500Hz / F1000Hz
- Minimum receiver refresh rate: 25Hz
- Working voltage: 4.5-12.4V
- Weight: 1.4g (Including two antenna)
- Dimension: 22mm13mm4mm
- Firmware Version: Express LRS v3.3.1 pre-installed
- FW Target: Radio Master RP3 Diversity 2400 RX
- Bus interface: CRSF
- Backup Interface: UART
Traditional Binding
For traditional binding, the binding phrase must be commented out in user_ defines on the RX.
- Power off your transmitter
- Plug in and unplug your receiver three times
- Make sure the LED is doing a quick double blink, which indicates the receiver is in bind mode
- Use the [BIND] button on the Express LRS Lua script, which sends out a binding pulse
- If the receiver has a solid light, it’s bound!
| Status light| Meaning
---|---|---
Receiver disconnected| Slow flash (500ms)| Waiting for transmitter
WIFI upgrade mode| Fast flash (25ms)| WIFI On
Bind mode| Double flash| Receiver in bind mode
Mode matching failed| Triple flash| Receiver functional, mode selection error
Receiver connected| Solid| Receiver functional
For more information, please visit the ELRS website:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>