GLOW SHIFT Fuel Line Pressure T Fitting Adapter Instruction Manual

GLOW SHIFT Fuel Line Pressure T Fitting Adapter

Specifications

• Product Name: Fuel Line Pressure T-Fitting Adapter
• Compatibility: 1/8-27 NPT fuel pressure sensor and vehicle’s rubber fuel line
• Material: Barbed T-Fitting
• Recommended Usage: Feed line to the fuel rail or supply line from the fuel pump

Product Usage Instructions

1. Locate the Fuel Line: Identify the fuel line on the vehicle where the T-Fitting will be installed.
2. Cut the Fuel Line: Cut the rubber fuel line to create space for the T-Fitting installation. Place hose clamps over the cut end and lubricate the T-Fitting.
3. Install T-Fitting: Press the T-Fitting into the cut ends firmly until fully seated. Secure it with hose clamps.
4. Thread the Sensor: Screw the fuel pressure sensor into the T-Fitting using Teflon tape or thread sealant to prevent leaks.
5. Prime the Fuel System: Remove air from the system by priming it.
6. Check for Leaks: Start the engine and inspect for any leaks at the T-Fitting connections.

FAQ

Q: Can I use this T-Fitting with any fuel pressure sensor?

• A: The T-Fitting is compatible with 1/8-27 NPT fuel pressure sensors.

Q: How do I ensure a proper seal when installing the fuel pressure sensor?

• A: Use Teflon tape or thread sealant on the sensor’s threads to prevent leaks.

Q: What should I do if I notice a leak after installation?

• A: Double-check the installation, ensure proper tightening, and replace any damaged components if needed.

INSTALLATION INSTRUCTIONS

Fuel Line Pressure T-Fitting Adapter

This Barbed Fuel Pressure T-Fitting Adapter allows you to install your 1/8-27 NPT fuel pressure sensor into your vehicle’s rubber fuel line.

1. Locate the fuel line on the vehicle that you are planning to install the barbed T-Fitting into. We recommend using the feed line to the fuel rail or the supply line coming from the fuel pump.
2. Cut the rubber fuel line in half on a location where the T-fitting has sufficient room to be installed.
   • Insert the hose clamps over the cut ends of the line and lubricate both ends of the T-Fitting.
3. Install the T-Fitting into the two cut ends by firmly pressing the hose until fully seated. Secure the TFitting to the fuel line using the hose clamps.
4. Thread the fuel pressure sensor into the T-Fitting.
   • Use Teflon tape or thread sealant on the threads to prevent any leaks.
5. Prime the fuel system and make sure that all of the air has been purged from the fuel system.
6. Start the engine and verify that there are no leaks at the T-Fitting connections.

• GlowShift Gauges, LLC
• 444 Commerce Lane Suite A, West Berlin, NJ 08091
• GlowShift.com
• 856.768.8300
• Support@GlowShiftGauges.com

Documents / Resources

| GLOW SHIFT Fuel Line Pressure T Fitting Adapter [pdf] Instruction Manual
Fuel Line Pressure T Fitting Adapter, Fuel Line, Pressure T Fitting Adapter, T Fitting Adapter, Fitting Adapter, Adapter
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>